Szymon Woźniak

Mr. Szymon Woźniak

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 December 2018 in IEEE Signal Processing Letters
Verified
Journal Article
Closed access
SWSzymon Woźniak
Szymon Woźniak
KKKonrad Kowalczyk
Konrad Kowalczyk
Collaborative processing of signals recorded by distributed sensors brings about new opportunities as well as challenges to classical array signal processing. In this letter, we present a method for passive self-calibration of a distributed system in which each distributed node consists of an array of sensors. The proposed method estimates the positions and orientations of distributed sensor arrays, the synchronization timeline offsets as well as the positions of spatially distributed events emitted by an uncontrolled source or sources. The proposed two-step optimization consists in finding the maximum likelihood estimate of the relative geometry of a distributed system based on Directions of Arrival (DoAs) observed independently at each array. Next the final positions of distributed arrays, the positions of acoustic events, and the synchronization offsets between the nodes are computed by solving a linear Least Square (LS) problem based on the observed Time Differences of Arrival (TDoAs) between the arrays and the relative positions estimated in the first optimization step. The evaluation results indicate that passive self-calibration of distributed sensor arrays can be conveniently achieved by observing acoustic events generated by an uncontrolled source based on the measured DoAs and TDoAs.

1 May 2020
Verified
Conference Paper
Closed access
SWSzymon Woźniak
Szymon Woźniak
KKKonrad Kowalczyk
Konrad Kowalczyk
Many signal processing algorithms for distributed sensors are capable of improving their performance if the positions of sensors are known. In this paper, we focus on estimators for inferring the relative geometry of distributed arrays and sources, i.e. the setup geometry up to a scaling factor. Firstly, we present the Maximum Likelihood estimator derived under the assumption that the Direction of Arrival measurements follow the von Mises-Fisher distribution. Secondly, using unified notation, we show the relations between the cost functions of a number of state-of-the-art relative geometry estimators. Thirdly, we derive a novel estimator that exploits the concept of rays between the arrays and source event positions. Finally, we show the evaluation results for the presented estimators in various conditions, which indicate that major improvements in the probability of convergence to the optimum solution over the existing approaches can be achieved by using the proposed ray-based estimator.


5 December 2016
Verified
Conference Paper
Closed access
KKKonrad Kowalczyk
Konrad Kowalczyk
SWSzymon Woźniak
Szymon Woźniak
TCTomasz Chyrowicz
Tomasz Chyrowicz
RRRoman Rumian
Roman Rumian
Enhancing speech from audio signals recorded using several microphones is of interest to many audio applications such as human-computer interfaces and teleconference systems. With an increasing availability of low-cost micro-electro-mechanical systems (MEMS) and powerful processing units, embedded systems are capable of recording and processing several audio signals in realtime. In this paper, an overview of the entire signal processing chain from audio signal acquisition with an array of MEMS microphones to the signal enhancement using directional filtering is provided. The presented results indicate that good noise and interference suppression can be achieved in realtime using an embedded system equipped with low-cost microphones.

25 December 2023 in Sensors
Verified
Journal Article
Open access
PDF file
SWSzymon Woźniak
Szymon Woźniak
KKKonrad Kowalczyk
Konrad Kowalczyk
The network of distributed microphone arrays is usually established in an ad hoc manner; hence, network parameters such as the mutual positioning and rotation of the arrays, positions of sources, and synchronization of their recording onset times are initially unknown. In this article, we consider the problem of passively jointly self-calibrating and synchronizing distributed arrays in reverberant rooms. We use a typical two-step approach where, initially, the relative geometry of the network is estimated using Direction of Arrival (DoA) measurements. Subsequently, the absolute scale and synchronization parameters are estimated using Time Difference of Arrival (TDoA) measurements. This article presents methods to improve the robustness and accuracy of estimation of the absolute geometric scaling and synchronization parameters in reverberant conditions, in which TDoA measurements do not follow a normal distribution; furthermore, outliers often occur. To remedy these issues, we propose a Weighted Least Squares (WLS) estimator and schema for weighting the TDoA measurements to increase the estimation accuracy from heteroscedastic TDoA measurements. In addition, we propose an iterative reweighing algorithm with a binary weight to detect and reject TDoA outliers, which exploits the residuals of the parametric model in the least absolute value minimization. A numerical evaluation shows significant improvements in the proposed method over the state of the art in terms of the relative scaling error and mean absolute value of the synchronization parameters.

1 February 2020 in arXiv
Verified
Preprint
Open access
PDF file
SWSzymon Woźniak
Szymon Woźniak
KKKonrad Kowalczyk
Konrad Kowalczyk
Many signal processing algorithms for distributed sensors are capable of improving their performance if the positions of sensors are known. In this paper, we focus on estimators for inferring the relative geometry of distributed arrays and sources, i.e. the setup geometry up to a scaling factor. Firstly, we present the Maximum Likelihood estimator derived under the assumption that the Direction of Arrival measurements follow the von Mises-Fisher distribution. Secondly, using unified notation, we show the relations between the cost functions of a number of state-of-the-art relative geometry estimators. Thirdly, we derive a novel estimator that exploits the concept of rays between the arrays and source event positions. Finally, we show the evaluation results for the presented estimators in various conditions, which indicate that major improvements in the probability of convergence to the optimum solution over the existing approaches can be achieved by using the proposed ray-based estimator.