The thermophysical and electrical properties of graphene–transformer oil nanofluid at three weight percentage concentrations (0.01%, 0.03%, and 0.05%) were experimentally studied. Experiments conducted to find viscosity, surface tension, density, specific resistance, electrical conductivity, and dielectric dissipation at various temperatures ranging from 20 °C to 90 °C. It was noted that the nanofluid with 0.05% concentration showed an enhancement of 2.5% and 16.6% for density and viscosity, respectively, when compared to transformer oil. In addition, an average reduction in surface tension is noted to be 10.1% for the maximum concentration of nanofluid. Increase in heat load and concentration improves Brownian motion and decreases the cohesive force between these particles, which results in a reduction in surface tension and increases the heat-transfer rate compared to transformer oil. In addition, for the maximum concentration of nanoparticles, the electrical conductivity of nanofluid was observed to be 3.76 times higher than that of the transformer oil at 90 °C. The addition of nanoparticles in the transformer oil decreases the specific resistance and improves the electrical conductivity thereby enhancing the breakdown voltage. Moreover, the thermophysics responsible for the improvement in thermophysical and electrical properties are discussed clearly, which will be highly useful for the design of power transmission/distribution systems.
13 June 2017 in Journal of Thermal Science and Engineering Applications
This numerical study has been carried out by developing two-phase mixture model with conjugate heat transfer. Pure and hybrid nanofluids (HyNF) with particle as well as base fluid hybridization are used in analyzing the performance of microchannel under forced convection laminar flow. The flow as well as heat transfer characteristics of pure water, copper (Cu), aluminum (Al), single-walled carbon nanotube (SWCNT), and hybrid (Cu + Al, water + methanol) nanofluids with various nanoparticle volume concentrations at different Reynolds numbers are reported. Sphericity-based effective thermal conductivity evaluation is considered in the case of SWCNT nanofluids by using volume and surface area of nanotubes. A significant enhancement in the average Nusselt number is observed numerically for both pure and hybrid nanofluids. Pure nanofluids such as Al, Cu, and SWCNT with 3 vol % nanoparticle concentration enhanced the average Nusselt number by 21.09%, 32.46%, and 71.25% in comparison with pure water at Re = 600. Whereas, in the case of hybrid nanofluids such as 3 vol % HyNF (0.6% Cu + 2.4% Al) and 3 vol % SWCNT (20% Me + 80% PW), the enhancement in average Nusselt number is observed to be 23.38% and 46.43% in comparison with pure water at Re = 600. The study presents three equivalent combinations of nanofluids (1 vol % Cu and 0.5 vol % SWCNT), (2 vol % Cu, 1 vol % SWCNT and 3 vol % HyNF (0.6% Cu + 2.4% Al)) as well as (2 vol % SWCNT and 3 vol % SWCNT (20% Me + 80% PW)) that provides a better switching option in choosing efficient working fluid with minimum cost based on cooling requirement. The study also shows that by dispersing SWCNT nanoparticles, one can enhance the heat transfer characteristics of base fluid containing methanol as antifreeze. The conduction phenomena of solid region cause the interface temperature between solid as well as fluid regions to increase along the length of the microchannel. The developed numerical model is validated with the numerical and experimental results available in the literature.