Center for Environmental Solutions and Emergency Response, Office of Research and Development, U.S. Environmental Protection Agency, Cincinnati, OH 45268, USA
Dr. Mohamed M. M Hantush
Center for Environmental Solutions and Emergency Response, Office of Research and Development, U.S. Environmental Protection Agency, Cincinnati, OH 45268, USA
This paper applies the Soil Water Assessment Tool (SWAT) to model the hydrology in the Pocono Creek watershed located in Monroe County, Pa. The calibrated model will be used in a subsequent study to examine the impact of population growth and rapid urbanization in the watershed on the base flow and peak runoff. Of particular interest in this paper is the exploration of potential use of Next Generation Weather Radar (NEXRAD) technology as an alternative source of precipitation data to the conventional surface rain gauges. NEXRAD estimated areal average precipitations are shown to compare well with the gauge measured ones at two climate stations in the study area. Investigation of the spatially distributed NEXRAD precipitation estimates revealed that average annual precipitation can vary spatially as much as 12% in the Pocono Creek watershed. The SWAT model is calibrated and validated for monthly stream flow, base flow, and surface runoff. Hydrographs generated from both gauge and NEXRAD driven model simula...
1 September 2014 in Journal of Hydrologic Engineering
A formal Bayesian methodology is presented for integrated model calibration and risk-based water quality management using Bayesian Monte Carlo simulation and maximum likelihood estimation (BMCML). The primary focus is on lucid integration of model calibration with risk-based water quality management and total maximum daily load (TMDL) estimation under conditions of uncertainty. The sources of uncertainty considered in the analysis are modeling errors, observational data errors and fuzziness of the water quality standard. The difference between observed data or transformation thereof and corresponding model response is assumed to follow first-order Markov process, a specific case of which is statistically independent Gaussian errors. The BMCML method starts with sampling parameter sets from prior probability distributions of the model parameters and uses Bayes theorem and the maximum likelihood technique to estimate the triplicate (variance of residual errors, bias and autocorrelation coefficient o...
1 May 1989 in Journal of Water Resources Planning and Management
A chance‐constrained optimization model for a stream‐aquifer system is developed using an approximate solution for the transient drawdown of the water table of an aquifer by a well operating near a river. The model explicitly considers the random nature of the hydraulic conductivity and specific yield of an unconfined aquifer. This enables the determination of the optimal groundwater pumping pattern and induced recharge from the stream to the aquifer (i.e., stream depletion rate) under specified system performance probability requirements. An application of the model is demonstrated using a hypothetical problem, and the sensitivity of the results is examined by varying probability requirements and the statistical properties of the aquifer parameters, which are: the coefficient of variation of the loghydraulic conductivity; the coefficient of variation of the log‐specific yield; and the correlation between the log‐hydraulic conductivity and log‐specific yield. The results obtained by the model indicate that the optimal pattern of pumping rates obtained by the management policy are highly sensitive to the probability levels and coefficient of variation of the log‐hydraulic conductivity. The induced rate of stream depletion is insensitive to the coefficient of variation of the log‐specific yield and is slightly sensitive to the probability levels. In contrast, the induced stream depletion rate is highly sensitive to the hydraulic conductivity statistics.
Hydrological models are evaluated by comparisons with observed hydrological quantities such as streamflow. A model evaluation procedure should account for dominantly epistemic errors in hydrological data such as model input precipitation and streamflow and avoid type-2 errors (rejecting a good model). This study uses quantile random forest (QRF) to develop limits-of-acceptability (LoA) over streamflows that account for uncertainties in precipitation and streamflow values. A significant advantage of this method is that it can be used to evaluate models even at ungauged basins. This method was used to evaluate a hydrological model –Sacramento Soil Moisture Accounting (SAC-SMA) – over the St. Joseph River Watershed (SJRW) for both gauged and hypothetical ungauged scenarios. QRF defined wide LoAs that yielded a large number of models as behavioral, suggesting the need for additional measures to develop a more discriminating inference procedure. The paper discusses why the LoAs defined by QRF were wide, along with some ways to define more discriminating LoAs. To further constrain the model, five streamflow-based signatures (i.e., autocorrelation function, Hurst exponent, baseflow index, flow duration curve, and long-term runoff coefficient) were used. The combination of LoAs over streamflow and streamflow-based signatures helped constrain the set of behavioral models in both the gauged and the ungauged scenarios. Among the signatures used in this study, the Hurst exponent and baseflow index were the most useful ones. All the 1-million models evaluated in this study were eventually rejected as unfit-for-purpose.
Spatial variability of aquifer properties and hydraulic heads are modeled as random fields, and their estimates are achieved by Kalman filtering. The state-space equation is developed from a quasi-analytical solution of a first-order approximation of the governing stochastic flow equation. In the state-space system, the effects of aquifer heterogeneity and uncertainty in recharge are lumped linearly into a random noise vector that is correlated in time. To account for the correlated system noise, we reformulate the problem in terms of an augmented–state-space system and use the resulting Kalman filtering recursions to estimate transmissivities, storativities, and hydraulic heads, simultaneously. The filter is applied to a numerical experiment in which the statistical parameters of log aquifer properties are assumed to be known. The results indicate that under mild head gradients, head measurements alone are of limited value if the objective is to estimate the spatial distribution of aquifer transmissivity and storativity. Ultimately, measurements of the aquifer properties may be required for reliable estimation of their unknown values.