Cold recycling of asphalt pavements proved to be an effective maintenance and rehabilitation technology for both environmental and economic reasons. Nevertheless, the use of cold-recycled (CR) asphalt mixtures requires a careful assessment of their mechanical properties, especially when they are designed to replace traditional hot-mix asphalt concrete (AC) mixtures. In this study, the potential use of a CR asphalt mixture as base course of an Italian motorway was evaluated. The studied mixture was produced in a central plant employing high-reclaimed asphalt (RA) content and used to construct two experimental sections along an in-service Italian motorway. In particular, a special mixing procedure, involving the use of water vapour and bituminous emulsion, was tested. A third experimental section was constructed with the same layer thickness using the AC mixture currently used in rehabilitation projects, incorporating 30% of RA. Volumetric properties, stiffness, resistance to permanent deformation and fatigue behaviour of mixtures were investigated by performing tests on samples cored from the three test sections and on laboratory-compacted samples. Results of the mechanical tests showed that CR mixtures provide lower stiffness modulus and lower resistance to repeated loading, but better resistance to permanent deformation when compared with AC. This behaviour can be explained due to the presence of cementitious bonds that reduce thermal sensitivity and viscous response.
1 April 2014 in Construction and Building Materials
The rheological properties of the bituminous components (bitumen and bituminous mastic) within asphalt mixtures contribute significantly to the major distresses of flexible pavements (i.e. rutting, fatigue and low temperature cracking). Asphalt mixtures are usually composed of mastic-coated aggregates rather than pure bitumen-coated aggregates. The purpose of this study is to investigate the effects of mineral fillers on the rheological behaviour of several polymer-modified bitumens (PMBs) through laboratory mixing. A neat bitumen and two types of polymers (elastomeric and plastomeric) were used to produce PMBs, and two fillers with different minerals (limestone and basalt) were selected to obtain mastics. The dynamic shear rheometer (DSR) and bending beam rheometer (BBR) were used to characterize the rheological properties of PMBs and mastics. In particular, multiple stress creep recovery (MSCR) tests were performed to evaluate the rutting potential at high temperatures, whereas BBR tests were carried out to investigate the low temperature behaviour of these materials. BBR results for unmodified mastics show that the increase of stiffness is similar regardless of the filler type, whereas results for polymer-modified mastics indicate that the degree of stiffening depends on the combination of filler/polymer types. MSCR results show that adding filler leads to a reduced susceptibility of permanent deformation and an enhanced elastic response, depending on the combination of filler/polymer types. Overall results suggest that a physical–chemical interaction between the filler and bitumen occurs, and that the interaction level is highly dependent on the type of polymer modification