The demand for mechanically robust polymer-based electrolytes is increasing for applications to wearable devices. Young’s modulus and breaking energy are essential parameters for describing the mechanical reliability of electrolytes. The former plays a vital role in suppressing the short circuit during charge-discharge, while the latter indicates crack propagation resistance. However, polymer electrolytes with high Young’s moduli are generally brittle. In this study, a tough slide-ring solid polymer electrolyte (SR-SPE) breaking through this trade-off between stiffness and toughness is designed on the basis of strain-induced crystallization (SIC) and phase separation. SIC makes the material highly tough (breaking energy, 80 to 100 megajoules per cubic meter). Phase separation in the polymer enhanced stiffness (Young’s modulus, 10 to 70 megapascals). The combined effect of phase separation and SIC made SR-SPE tough and stiff, while these mechanisms do not impair ionic conductivity. This SIC strategy could be combined with other toughening mechanisms to design tough polymer gel materials.

The neutron instruments suite, installed at the spallation neutron source of the Materials and Life Science Experimental Facility (MLF) at the Japan Proton Accelerator Research Complex (J-PARC), is reviewed. MLF has 23 neutron beam ports and 21 instruments are in operation for user programs or are under commissioning. A unique and challenging instrumental suite in MLF has been realized via combination of a high-performance neutron source, optimized for neutron scattering, and unique instruments using cutting-edge technologies. All instruments are/will serve in world-leading investigations in a broad range of fields, from fundamental physics to industrial applications. In this review, overviews, characteristic features, and typical applications of the individual instruments are mentioned.

Chemically modified carbon supports for the cathode catalyst layers of polymer electrolyte fuel cells (PEFCs) show considerable promise for boosting the oxygen reduction reaction. This study evaluated the ionomer distribution of Nafion ionomer thin films on nitrogen (N)-modified carbon surfaces along their depth direction. Neutron reflectivity (NR) measurements performed using the double-contrast technique with H₂O and D₂O revealed that the introduction of N functional groups to carbon thin films promoted ionomer adsorption onto the surface under wet conditions (22 °C, 85% relative humidity). Molecular dynamics (MD) simulations conducted to verify the origin of the robust contact between the ionomer and N-modified carbon surface revealed an ionomer adsorption mechanism on the N-modified carbon surfaces, which involved Coulomb interactions between the positively charged carbon surface and the ionomer side chains with negatively charged sulfonic acid groups. The positive surface charge, which was determined using the contents of the N functional groups estimated by X-ray photoelectron spectroscopy, was found to be sufficient as an impetus for ionomer adsorption. This strategy involving NR measurements and MD simulations can provide insights into the solid-ionomer interfacial structures in a cathode catalyst layer and can therefore be extensively employed in studies on PEFCs.

A chemical reaction between epoxy and amine compounds at an outermost solid interface was studied by sum-frequency generation spectroscopy, X-ray and neutron reflectivity and a full atomistic molecular dynamics simulation.