A combination of gel-casting and polymeric foam infiltration methods is used in this study to prepare porous bodies of hydroxyapatite (HA), to provide a better control over the microstructures of samples. These scaffolds were prepared by impregnating a body of porous polyurethane foam with slurry containing HA powder, and using a percentage of solids between 40% and 50% w/v, and three different types of monomers to provide a better performance. X-Ray Diffraction (XRD), and Fourier Transformed Infrared (FTIR) and Scanning Electron Microscopy (SEM) were employed to evaluate both the powder hydroxyapatite and the scaffolds obtained. In addition, porosity and interconnectivity measurements were taken in accordance with the international norm. Bioactivity was checked using immersion tests in Simulated Body Fluids (SBF). After the sintering process of the porous bodies, the XRD results showed peaks characteristic of a pure and crystalline HA (JCPDS 9-432) as a single phase. SEM images indicate open and interconnected pores inside the material, with pore sizes between 50 and 600 μm. Also, SEM images demonstrate the relatively good bioactivity of the HA scaffolds after immersion in SBF. All results for the porous HA bodies suggest that these materials have great potential for use in tissue engineering.
The gel-casting technique has been implemented by several investigators, due to the fact that it presents a great potential to manufacture porous ceramic bodies with high mechanical resistance, complex geometries, and high dimensional precision. The hydroxyapatite (HA) is a ceramic that allows not also the bioactive fixation, but cells and nutrients invasion to promote the tissue regeneration; however, it presents low mechanical resistance. In this study, hydroxyapatite foams -using gel-casting with two different monomers and percent solids of 40 and 50%- were prepared. Obtained foams were characterized by X Ray-Diffraction (XRD), by Scanning Electron Microscope (SEM), by porosity and interconnectivity determination and by bioactivity assay. The results shown that the manufactured foams present open and interconnected porous with approximate size of 200 μm, porosity of 67%, and interconnectivity of 60%. The immersion tests in SBF confirmed the bioactivity of the hydroxyapatite, which demonstrates that this is a high potential process to manufacture porous bodies with useful characteristics in tissue engineering.