The synthesis of conjugated copolymers with glycolated thieno[3,2-b]thiophene units by direct arylation polymerization, their synthetic complexity in the context of literature compounds, and their performance in organic electrochemical transistors is described.
Conjugated polymers are widely studied for application areas ranging from energy technology to wearable electronics and bioelectronics. To develop a truly sustainable technology, environmentally benign synthesis is essential. Here, the open-flask synthesis of a multitude of conjugated polymers at room temperature by ambient direct arylation polymerization (ADAP) is demonstrated. The batch synthesis of over 100 grams of polymer in a green solvent and continuous droplet flow synthesis without any solid support is described. Polymers prepared by ADAP are characterized by improved structural order compared to materials prepared by other methods. Hence, organic electrochemical transistors (OECTs) feature beyond state-of-the-art electrical properties, i.e., an OECT hole mobility μ as high as 6 cm 2 V −1 s −1 , a volumetric capacitance C* over 200 F cm −3 , and thus a figure of merit [μ C* ] exceeding 1100 F cm −1 V −1 s −1 . Thus, ADAP paves the way for the benign and large-scale production of high-performance conjugated polymers.
14 October 2024 in Journal of Materials Chemistry C
Organic electrochemical transistors (OECTs) have garnered significant attention due to their exceptional capability to efficiently monitor biological signals, making them an ideal platform for bio-signal detection. Many recent research studies have focused on detecting alkali-metal cations, such as the key cellular messengers of sodium (Na+) and potassium (K+) ions. We now report a straightforward and effective method for fabricating membraneless ion-selective OECTs (IS-OECTs) by directly incorporating crown ethers, specifically 18-crown-6 (18C6) and 15-crown-5 (15C5) ethers, into a polymer matrix of p(g2T-TT), a conjugated polymer bearing glycol side chains. The resulting IS-OECTs demonstrated good sensitivity and a low limit of detection for both Na+ and K+ ions. Importantly, stability tests revealed that 15C5-mixed polymer OECTs show no degradation over 450 continuous cycles in a NaCl aqueous solution, underscoring the excellent retention performance. This study not only provides a facile and efficient approach for the development of ion detection systems based on OECTs but also opens new avenues for advancing bioelectronic devices in future research endeavors.
The elastic modulus is a critical parameter for the design of conjugated polymers for wearable electronics and correlates with electrical and thermal transport. Yet, widely different values have been reported for the same material because of the influence of processing and measurement conditions, including the temperature, mode, direction, and time scale of deformation. Thus, results obtained via different methods are usually not considered to be comparable. Here, disparate techniques from nanoindentation to tensile testing of free-standing films or films on water, buckling analysis, dynamic mechanical thermal analysis, oscillatory shear rheometry, and atomic force microscopy are compared. Strikingly, elastic modulus values obtained for the same batch of regioregular poly(3-hexylthiophene) differ by a factor of less than four, which suggests that an approximate comparison is possible. Considering the small amount of material that is typically available, nanoindentation in combination with creep analysis is identified as a reliable method for probing the elastic modulus of films with widely different elastic moduli ranging from less than 0.1 GPa in the case of a polythiophene with oligoether side chains to several GPa for polymers without side chains. Since films can display anisotropic elastic modulus values, it is proposed that nanoindentation is complemented with an in-plane technique such as tensile testing to ensure a full characterization using different modes of deformation.