The dehydration behavior of turkey berries was analysed in a fluidized bed dryer at various inlet air velocities (0.8, 2.1, and 3.4m/s) and temperatures (50, 60, and 70C). The drying parameters and physiochemical values of fruits were extensively studied, as were the moisture content, rate of drying, moisture diffusivity of the sample, shrinking percentage, color variations, retention of vitamin C, β-carotene, antioxidant capacity, and total phenolic content. The activation energy varies between 36.82 and 45.63kJ/mol under different bed conditions. According to the experimental results, it has been observed that the maximum moisture diffusion rate was 2.89810−10m2/s and maximum retention rates of vitamin C, β-carotene, antioxidant capacity, and total phenolic content were 1.91mg/100g d.m, 184μg/100g d.m, 21.34mg AAE/100g d.m, and 513mg GAE/100g, during the drying of the sample at 70C and 3.4m/s. The minimum shrinkage (49.1) and color variation (E=11.08) were detected at 3.4m/s and 70C. The Midilli et al. model was fitted, which is the most preferable model for predicting the dehydration characteristics of turkey berries.
1 January 2024 in Brazilian Archives of Biology and Technology
The primary objective of this investigation, the influence of chemical, combined chemical, hybrid pre-treated samples and the addition of inert material into turkey berry samples through the fluidized bed dryer was studied at processing air temperature of 70 0C and an inlet air flow of 4.2 m/s, as well as compared to sun drying. Results showed that the Hybrid-II treatments as well as the addition energy carrier method reduced drying time around by 12 times and 10 times compared to open sun-dried samples. The Hybrid-II pre-treatment method resulted in the quickest drying procedure, and it was completed in 330 minutes. In addition, the lowest shrinkage of around 39%, tolerable color change, and the maximum retention of vitamin-C were achieved compared to both OSD and un-treated samples. The Midilli and coauthors (2002) [1 1 Midilli AD, Kucuk HA, Yapar Zİ. A new model for single-layer drying. Drying Technol. 2002 Jul 23; 20(7):1503-13. ] model was fitted, the most preferable model for predicting the drying characteristics of Turkey berry.
18 April 2025 in Journal of Environmental Nanotechnology
The current study is aimed at the resolution of engine issues associated with higher viscosities found in biodiesel, such as rubber seed oil, through the blending of waste plastic oil. The experiments involved using a hybrid biodiesel made by blending rubber seed oil with waste plastic oil in volume proportions of 20%, 30%, and 40%. The results demonstrate that the hybrid alternative biodiesel, which comprises a blend of 20% rubber seed oil and 80% waste plastic oil (denoted as R 20 P 80), provides a brake thermal efficiency of 25.8% and a brake specific fuel consumption of 0.41 kg/kW-h. In addition, the R 20 P 80 blend exhibits higher oxides of nitrogen emissions by approximately 100 ppm and an increase of 0.07% volume in carbon monoxide emissions than that of diesel at maximum load. Additionally, the hydrocarbon releases are about 5 ppm higher, and the smoke opacity emission increases by 1% at full load for the R 20 P 80 blend compared to diesel. The findings imply that this hybrid biodiesel holds promise for use in a range of industries, including transportation, power generation, cultivation and farming, industrial and commercial applications, marine and shipping, aviation, residential heating, military applications, public transportation, off-road and recreational vehicles, and more.