The treadmill is an attractive device for the investigation of human locomotion, yet the extent to which lower limb kinematics differ from overground running remains a controversial topic. This study aimed to provide an extensive three-dimensional kinematic comparison of the lower extremities during overground and treadmill running. Twelve participants ran at 4.0 m/s ( ± 5%) in both treadmill and overground conditions. Angular kinematic parameters of the lower extremities during the stance phase were collected at 250 Hz using an eight-camera motion analysis system. Hip, knee, and ankle joint kinematics were quantified in the sagittal, coronal, and transverse planes, and contrasted using paired t-tests. Of the analysed parameters hip flexion at footstrike and ankle excursion to peak angle were found to be significantly reduced during treadmill running by 12° (p = 0.001) and 6.6° (p = 0.010), respectively. Treadmill running was found to be associated with significantly greater peak ankle eversion (by 6.3°, p = 0.006). It was concluded that the mechanics of treadmill running cannot be generalized to overground running.

Errors in kinematic data are referred to as noise and are an undesirable portion of any waveform. Noise is typically removed using a low-pass filter which removes the high frequency components of the signal. The selection of an optimal frequency cut-off is very important when processing kinematic information and a number of techniques exists for the determination of an optimal frequency cut-off. Despite the importance of cut-off frequency to the efficacy of kinematic analyses there is currently a paucity of research examining the influence of different cut-off frequencies on the resultant 3-D kinematic waveforms and discrete parameters. Twenty participants ran at 4.0 m•s-1 as lower extremity kinematics in the sagittal, coronal and transverse planes were measured using an eight camera motion analysis system. The data were filtered at a range of cut-off frequencies and the discrete kinematic parameters were examined using repeated measures ANOVA’s. The similarity between the raw and filtered waveforms were examined using intra-class correlations. The results show that the cut-off frequency has a significant influence on the discrete kinematic measure across displacement and derivative information in all three planes of rotation. Furthermore, it was also revealed that as the cut-off frequency decreased the attenuation of the kinematic waveforms became more pronounced, particularly in the coronal and transverse planes at the second derivative. In conclusion, this investigation provides new information regarding the influence of digital filtering on lower extremity kinematics and re-emphasizes the importance of selecting the correct cut-off frequency.

Background: Barefoot running has been the subject of much attention in footwear biomechanics literature, based on the supposition that it serves to reduce the occurrence of overuse injuries in comparison to conventional shoe models. This consensus has led footwear manufacturers to develop shoes that aim to mimic the mechanics of barefoot locomotion. Objectives: This study compared the impact kinetics and three-dimensional (3-D) joint angular kinematics observed while running barefoot, in conventional cushioned running shoes and in shoes designed to integrate the perceived benefits of barefoot locomotion. The aim of the current investigation was therefore to determine whether differences in impact kinetics exist between the footwear conditions and whether shoes that aim to simulate barefoot movement patterns can closely mimic the 3-D kinematics of barefoot running. Method: Twelve participants ran at 4.0 m s⁻¹ (±5%) in each footwear condition. Angular joint kinematics from the hip, knee and ankle in the sagittal, coronal and transverse planes were measured using an eight-camera motion analysis system. In addition, simultaneous tibial acceleration and ground reaction forces were obtained. Impact parameters and joint kinematics were subsequently compared using repeated-measures analyses of variance (ANOVAs). Results: The kinematic analysis indicated that, in comparison to the conventional and barefoot-inspired shoes, running barefoot was associated with significantly greater plantar–flexion at footstrike and range of motion to peak dorsiflexion. Furthermore, the kinetic analysis revealed that, compared to the conventional footwear, impact parameters were significantly greater in the barefoot condition. Conclusions: This study suggests that barefoot running is associated with impact kinetics linked to an increased risk of overuse injury when compared to conventional shod running. Furthermore, the mechanics of the shoes that aim to simulate barefoot movement patterns do not seem to closely mimic the kinematics of barefoot locomotion.

Carbohydrate (CHO) mouth rinse has been shown to improve time trial performance. Although the exact mechanism remains un‐established, research postulates that there are oral cavity receptors which increase neural drive. Increasing the duration of the mouth rinse could potentially increase stimulation of these receptors. The aim of the current investigation was to determine whether the duration of mouth rinse with 6.4% CHO affected 30‐min self‐selected cycling performance. Eleven male participants (age =24.1±3.9 years) performed three 30‐min self‐paced trials. On one occasion water was given as a mouth rinse for 5 s without being ingested placebo (PLA), on the other two occasions a 6.4% CHO solution was given for 5 and 10 s. Distance cycled, heart rate, ratings of perceived exertion, cadence, speed and power were recorded throughout all trials. The main findings were that distance cycled during the 10‐s mouth rinse trial (20.4±2.3 km) was significantly greater compared to the PLA trial (19.2±2.2 km; P<0.01). There was no difference between the 5‐ and 10‐s trials (P=0.15). However, 10 out of 11 participants cycled further during the 5‐s trial compared to PLA, and eight cycled further during the 10‐s trial compared to the 5 s. In conclusion, although there was an improvement in distance cycled with the 5‐s mouth rinse compared to the PLA it was only significant with 10 s suggesting a dose response to the duration of mouth rinse.

Since the ability to train the horse to be ambidextrous is considered highly desirable, rider asymmetry is recognized as a negative trait. Acquired postural and functional asymmetry can originate from numerous anatomical regions, so it is difficult to suggest if any is developed due to riding. The aim of this study was therefore to assess symmetry of posture, strength and flexibility in a large population of riders and to determine whether typical traits exist due to riding. 127 right handed riders from the UK and USA were categorized according to years riding (in 20 year increments) and their competition level (using affiliated test levels). Leg length, grip strength and spinal posture were measured and recorded by a physiotherapist. Standing and sitting posture and trunk flexibility were measured with 3-D motion capture technology. Right-left differences were explored in relation to years riding and rider competitive experience. Significant anatomical asymmetry was found for the difference in standing acromion process height for a competition level (-0.07±1.50 cm Intro/Prelim; 0.02±1.31 cm Novice; 0.43±1.27 cm Elementary+; p=0.048) and for sitting iliac crest height for years riding (-0.23±1.36 cm Intro/Prelim; 0.01±1.50 cm Novice; 0.86±0.41 cm Elementary+; p=0.021). For functional asymmetry, a significant interaction was found for lateral bending ROM for years riding x competition level (p=0.047). The demands on dressage riders competing at higher levels may predispose these riders to a higher risk of developing asymmetry and potentially chronic back pain rather than improving their symmetry