The research objective for this paper is to obtain a new extended and updated insight to the likely causes of construction accidents in Spain, in order to identify suitable mitigating actions. The paper analyzes all construction sector accidents in Spain between 2003 and 2008. Ten variables were chosen and the influence of each variable is evaluated with respect to the severity of the accident. The descriptive analysis is based on a total of 1,163,178 accidents. Results showed that the severity of accidents was related to variables including age, CNAE (National Classification of Economic Activities) code, size of company, length of service, location of accident, day of the week, days of absence, deviation, injury, and climatic zones. According to data analyzed, a large company is not always necessarily safer than a small company in the aspect of fatal accidents, experienced workers do not have the best accident fatality rates, and accidents occurring away from the usual workplace had more severe consequences. Results obtained in this paper can be used by companies in their occupational safety strategies, and in their safety training programs.
Fall from heights are a cause of concern in the construction sector. An appropriate use of the harness can be the difference between an incident or a critical accident. Monitoring the proper use of harness at workplace using Bluetooth Low Energy devices (BLE) is a recent and effective approach. The aim of the paper is to identify typical limitations in a BLE monitoring system in order to propose solutions according to the existing literature. Alternative solutions found in literature showed that the integration of BLE with other technologies such as Building Information Modeling (BIM), Radio Frequency Identification (RFID), or the Global Positioning System (GPS) can improve, the effectiveness of current monitoring approaches based only on BLE and reduce rates of fall from height accidents. For a correct integration, both technological factors (cost, compatibility, data transmission) and cultural factors (social acceptance, procedures, etc.) must be taken into account.
1 May 2015 in International Journal of Industrial Ergonomics