Amy Brunsvold

Dr. Amy Brunsvold

Department of Gas Technology, SINTEF Energy Research, NO-7465 Trondheim, Norway

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 August 2010 in Experiments in Fluids
Verified
Journal Article
Open access
PDF file
HZHe Zhao
He Zhao
ABAmy Brunsvold
Amy Brunsvold
SMSvend Tollak Munkejord
Svend Tollak Munkejord
An experimental investigation of droplets impinging vertically on a deep liquid pool of the same fluid was conducted. Coalescence and jetting as two of the main regimes were identified and studied. Five fluids, distilled water, technical ethanol, n-pentane, methanol and 1-propanol were used for providing different liquid-phase physical properties with density from 600 to 1,000 kg/m3, viscosity from 0.20 to 2.00 mPa s, and surface tension from 13.7 to 72.0 mN/m. Except for the experimental run of n-pentane, which was carried out in n-pentane saturated vapor, the ambient gas for the other experiments was air. The impact processes of micro-level (diameter below 1 mm) droplets were captured using a high-speed camera with a backlight. The observations, velocity and diameter ranges of the experimental runs were described, and based on them, the effects of the liquid-phase properties were studied. It was found that both low viscosity and low surface tension can increase the instability during impact processes. By curve-fitting, the transition from coalescence to jetting was characterized by using two models, one employing the Weber number (We) and the Ohnesorge number (Oh), and one employing the Froude number (Fr) and the Capillary number (Ca). Both models characterize the coalescence-jetting threshold well. The We-Oh model was based on a commonly used model from Cossali et al. (in Exp Fluids 22:463–472, 1997) for characterizing coalescence-splashing. For the small droplet diameters (below 1 mm) considered in this study, it was required to modify the We-Oh model with a diameter-dependent term to fit the sharp change in thresholds for fluids with relatively high viscosity. The Fr-Ca model has not previously been presented in the literature. A comparison of the two models with literature data (Rodriguez and Mesler, J Colloid Interface Sci 106(2):347–352, 1985) indicates that they are also valid for impacts of droplets with diameters above 1mm. Calculation methods to generalize the two models were proposed.

1 June 2018 in Advances in Colloid and Interface Science
Verified
Journal Article
Closed access
ISIngrid Snustad
Ingrid Snustad
IRIngeborg T Røe
Ingeborg T Røe
ABAmy Brunsvold
Amy Brunsvold
ÅEÅsmund Ervik
Åsmund Ervik
JHJianying He
Jianying He
ZZZhiliang Zhang
Zhiliang Zhang

1 November 2016 in International Journal of Greenhouse Gas Control
Verified
Journal Article
Closed access
ABAmy Brunsvold
Amy Brunsvold
JJJana P. Jakobsen
Jana P. Jakobsen
MMMarit J. Mazzetti
Marit J. Mazzetti
GSGeir Skaugen
Geir Skaugen
MHMorten Hammer
Morten Hammer
FNFilip Neele
Filip Neele

8 March 2020 in Clean Energy
Verified
Journal Article
Open access
ABAmy Brunsvold
Amy Brunsvold
GTGrethe Tangen
Grethe Tangen
SSSigmund Ø Størset
Sigmund Ø Størset
JDJames Dawson
James Dawson
ABAlvar Braathen
Alvar Braathen
MMMona J Mølnvik
Mona J Mølnvik
The NCCS is an international Centre for Environment-friendly Energy Research addressing CO2 CCS—key technology in the portfolio of measures instrumental in all energy scenarios outlining conceivable paths to curb global warming.

1 January 2011 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
PDF file
JZJianming Zhang
Jianming Zhang
ABAmy Brunsvold
Amy Brunsvold
HUHari P. Upadhyaya
Hari P. Upadhyaya
TMTimothy K. Minton
Timothy K. Minton
JCJon P. Camden
Jon P. Camden
GSGeorge C Schatz
George C Schatz
The reactions of O(3P) with HCl and H2O at hyperthermal collision energies (45–116 kcal mol−1) have been investigated with crossed‐molecular beams experiments and direct dynamics quasiclassical trajectory calculations. Both reactive systems may proceed by two analogous primary pathways, (1) H‐atom abstraction to produce OH and either Cl or OH and (2) H‐atom elimination to produce H and either ClO or HO2. The H‐atom elimination reactions are highly endoergic, and they have been observed experimentally for the first time. The H‐atom abstraction reaction follows a stripping mechanism, in which the reagent O atom approaches the target molecule at large impact parameters and the OH product is scattered in the forward direction with respect to the initial direction of the reagent O atom. The H‐atom elimination reaction requires low impact parameter collisions. The excitation function for ClO or HO2 increases from threshold to a maximum around 115 kcal mol−1 and then begins to decrease when the product can be formed with sufficient internal energy to undergo secondary dissociation. At collision energies slightly above threshold for H‐atom elimination, the ClO or HO2 product scatters primarily in the backward direction, but as the collision energy increases, the fraction of these products that scatter in the forward and sideways directions increases. The dependence of the angular distribution of ClO or HO2 on collision energy is a result of the fact that only certain trajectories, where an H atom on the target molecule is oriented toward the incoming reagent O atom, can release enough energy in translation to lead to stable ClO or HO2 at higher collision energies. These trajectories lead to forward and sideways scattering of ClO or HO2. Moreover, these trajectories do not follow the minimum path and involve larger translational energy release. Therefore, they become dominant at higher collision energies because they lead to lower internal energies and more stable ClO or HO2 products. The energy barrier for the O(3P)+H2O→HO2+H reaction was determined experimentally to be 60±2 kcal mol−1. Theory predicts that the H‐atom abstraction and elimination reactions have comparable cross sections for hyperthermal O(3P)+HCl collisions but that H‐atom elimination is only about 20 percent as probable as H‐atom abstraction for hyperthermal O(3P)+H2O collisions.

11 January 2026 in Energies
Verified
Journal Article
Open access
PDF file
MSMagdalena Strojny
Magdalena Strojny
Paweł GładyszPaweł Gładysz
Paweł Gładysz
ABAmy Brunsvold
Amy Brunsvold
Aneta MagdziarzAneta Magdziarz
Aneta Magdziarz
Carbon capture, utilization, and storage (CCUS) play an increasingly important role in climate mitigation strategies by addressing industrial emissions and enabling pathways toward net-negative emissions. A key challenge lies in determining the pathway of captured CO2, whether through permanent geological storage or conversion into value-added products to enhance system viability. As hard-to-abate sectors and the power industry remain major sources of emissions, a comprehensive assessment of the technical, environmental, and economic performance of CCUS pathways is essential. This study evaluates bioenergy with carbon capture and storage/utilization (BECCUS) in the context of the Polish energy sector. Techno-environmental performance was assessed across three pathways: CO2 storage in saline formations, CO2 mineralization, and methanol synthesis. The results show levelized costs of 59.9 EUR/tCO2,in for storage, 109.7 EUR/tCO2,in for mineralization, and 631.1 EUR/tCO2,in for methanol production. Corresponding carbon footprints (including full chain emissions) were −936.4 kgCO2-eq/tCO2,in for storage, −460.6 kgCO2-eq/tCO2,in in for mineralization, and 3963.4 kgCO2-eq/tCO2,in for methanol synthesis. These values highlight the trade-offs between economic viability and climate performance across utilization and storage options. The analysis underscores the potential of BECCS to deliver net-negative emissions and supports strategic planning for CCUS deployment in Poland.