Marijan Grgić

Dr. Marijan Grgić

University of Zagreb
orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 October 2020 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Marijan GrgićMarijan Grgić
Marijan Grgić
JBJosip Bender
Josip Bender
Tomislav BašićTomislav Bašić
Tomislav Bašić
Different space-borne geodetic observation methods combined with in-situ measurements enable resolving the single-point vertical land motion (VLM) and/or the VLM of an area. Continuous Global Navigation Satellite System (GNSS) measurements can solely provide very precise VLM trends at specific sites. VLM area monitoring can be performed by Interferometric Synthetic Aperture Radar (InSAR) technology in combination with the GNSS in-situ data. In coastal zones, an effective VLM estimation at tide gauge sites can additionally be derived by comparing the relative sea-level trends computed from tide gauge measurements that are related to the land to which the tide gauges are attached, and absolute trends derived from the radar satellite altimeter data that are independent of the VLM. This study presents the conjoint analysis of VLM of the Dubrovnik area (Croatia) derived from the European Space Agency’s Sentinel-1 InSAR data available from 2014 onwards, continuous GNSS observations at Dubrovnik site obtained from 2000, and differences of the sea-level change obtained from all available satellite altimeter missions for the Dubrovnik area and tide gauge measurements in Dubrovnik from 1992 onwards. The computed VLM estimates for the overlapping period of three observation methods, i.e., from GNSS observations, sea-level differences, and Sentinel-1 InSAR data, are −1.93±0.38 mm/yr, −2.04±0.22 mm/yr, and −2.24±0.46 mm/yr, respectively.

21 December 2015 in Survey Review
Verified
Journal Article
Closed access
MVMatej Varga
Matej Varga
Marijan GrgićMarijan Grgić
Marijan Grgić
Tomislav BašićTomislav Bašić
Tomislav Bašić
This paper presents empirical research on coordinate transformation models that enable coordinate transformations between the historical astro-geodetic datums and datums related to the European Terrestrial Reference System (ETRS), through a case study of the Republic of Croatia. Thirteen models were investigated for the transformation from the historical Croatian State Coordinate System (HDKS) to the Croatian Terrestrial Reference System (HTRS96): Molodensky 3 and 5 parameter (standard and abridged) conformal transformation models, 7 parameter transformation models (Bursa-Wolf and Molodensky-Badekas model), Affine transformation models (8, 9, 12 parameter), Multiple Regression Equation approach, and several transformation models that include extending of the aforementioned 7 parameter and 8, 9, 12 parameter Affine transformation models with distortion modelling. Most of the models were investigated for the first time over the Croatian territory. Analysis of transformation models performance was conducted using an independent data set of reliable geodetic points. The study provides mutual comparison of the models and their comparison with the official Croatian transformation model called T7D. Furthermore, the most appropriate transformation model(s) were defined regarding the required accuracy and the available resources for the coordinate transformation models implementation. In addition, the paper provides a brief theoretical background and equations of each transformation model and summarises the bibliography on the research topic.

22 June 2017 in Marine Geodesy
Verified
Journal Article
Closed access
Marijan GrgićMarijan Grgić
Marijan Grgić
RNRobert Steven Nerem
Robert Steven Nerem
Tomislav BašićTomislav Bašić
Tomislav Bašić
Changes in the height of the ocean can be described through the relative and absolute sea level changes depending on the geodetic reference the sea level records are related to. Satellite altimetry provides absolute sea level (ASL) measurements related to the global geodetic reference, whereas tide gauges provide relative sea level (RSL) measurements related to the adjacent land. This study aims at computing the ASL surfaces for different time epochs from combined satellite altimeter and tide gauge records. A method of sea level data fusion is proposed to enable modeling of the impact of present and future sea level changes on the coast. Sea surface modeling was investigated for ten different gridding methods commonly used for the interpolation of altimeter data over the open ocean and extrapolation over the coastal zones. The performance of gridding methods was assessed based on the comparison of the gridded altimeter data and corrected tide gauge measurements. Finally, the sea level surfaces related to the GRS80 global reference ellipsoid were computed for the Mediterranean Sea over the altimeter period. In addition, the current sea level trends were estimated from both sea level measurements.

30 June 2021
Verified
Book Chapter
Open access
PDF file
Marijan GrgićMarijan Grgić
Marijan Grgić
Tomislav BašićTomislav Bašić
Tomislav Bašić
Radar satellite altimetry has revolutionized our understanding of the Earth’s sea-level shape and its change over time, monitoring of the natural and human-induced water cycle, marine gravity computations, seafloor relief (bathymetry) reconstruction, tectonics, water mass balance change monitoring, etc., thus providing significant impact in geodesy. Today satellite radar altimetry is critical for unifying the vertical height systems, regional and global geoid modeling, monitoring of the sea level rise impact, monitoring of the ice sheet melting, and others. This chapter gives an overview of the technology itself and the recent developments including the SAR (Synthetic Aperture Radar) altimetry, coastal altimetry retracking methods, and new satellite missions (e.g. Sentinel-6). Besides, the chapter presents recent applied studies utilizing the altimeter data for ice sheet monitoring, vertical land motion estimating, bathymetric computations, and marine geoid modeling.

1 May 2016 in Journal of Surveying Engineering
Verified
Journal Article
Closed access
Marijan GrgićMarijan Grgić
Marijan Grgić
MVMatej Varga
Matej Varga
Tomislav BašićTomislav Bašić
Tomislav Bašić
Conformal coordinate transformations very often are not accurate enough to be used for the coordinate transformations between local and global geodetic datums because of the inhomogeneity of the spatial data in different geodetic datums. Therefore, distortion modeling is used to improve the accuracy of the coordinate transformations. This paper presents empirical research on distortion modeling methods used to improve the coordinate transformation process from local to global geodetic datum and vice versa. Various models of distortion shifts in different grid resolutions were computed, evaluated, and compared with the official Croatian model of distortion shifts. Tested modeling methods are inverse distance to a power, kriging, minimum curvature, modified Shepard’s method, natural neighbor, nearest neighbor, polynomial regression, radial basis function, triangulation with linear interpolation, moving average, local polynomial, and least-squares collocation. Distortion model performance was evalua...

1 January 2019 in Geofizika
Verified
Journal Article
Open access
MVMatej Varga
Matej Varga
Marijan GrgićMarijan Grgić
Marijan Grgić
OOOlga Bjelotomić Oršulić
Olga Bjelotomić Oršulić
Tomislav BašićTomislav Bašić
Tomislav Bašić
High-resolution digital elevation models (DEMs) have become available in the last decade. They are used in geodesy and geophysics as the main data for modeling of topographic mass effects included in gravimetric and gradiometric measurements. In modeling process, gravimeric terrain correction is the central quantity which accounts for the variations of topographic masses around measured stations. This study deals with one segment of terrain correction computation: the impact of the resolution of digital elevation models. Computations are performed on study area of Republic of Croatia. Newly created DEM/DBM for the study area is created from global digital surface model ASTER for continental area, and digital bathymetric model GEBCO for the sea area. DEMs with lower resolution were created by resampling of the created ASTER/GEBCO DEM/DBM in 1″ resolution. Terrain correction map is computed and published for the first time for the Republic of Croatia. The differences between terrain correction solutions obtained by using lower resolution DEMs compared to the solution obtained by using DEM with 1″ are indicating average influence of DEM resolution on terrain correction from 0,5·10–5 to 3·10–5 ms–2, for DEMs with lower resolution than 5″. The results also reveal that rugged and mountainous areas are particularly problematic in such computations.