Small magnetic sensors are widely used integrated in vehicles, mobile phones, medical devices, etc for navigation, speed, position and angular sensing. These magnetic sensors are potential candidates for space sector applications in which mass, volume and power savings are important issues. This work covers the magnetic technologies available in the marketplace and the steps towards their implementation in space applications, the actual trend of miniaturization the front-end technologies, and the convergence of the mature and miniaturized magnetic sensor to the space sector through the small satellite concept.
In this paper, we give an overview of the research on fluxgate magnetometers carried out in Spain. In particular we focus in the development of the planar-type instruments. We summarize the fabrication processes and signal processing developments as well as their use in complex systems and space.
A limited number of Anisotropic Magnetoresistive (AMR) commercial-off-the-shelf (COTS) magnetic sensors of the HMC series by Honeywell, with and without integrated front-end electronics, were irradiated with gamma rays up to a total irradiation dose of 200 krad (Si), following the ESCC Basic Specification No. 22900. Due to the magnetic cleanliness required for these tests a special set-up was designed and successfully employed. Several parameters of the sensors were monitored during testing and the results are reported in this paper. The authors conclude that AMR sensors without front-end electronics seem to be robust against radiation doses of up to 200 krad (Si) with a dose rate of 5 krad (Si)/hour and up to a resolution of tens of nT, but sensors with an integrated front-end seem to be more vulnerable to radiation.
24 February 2017 in Geoscientific Instrumentation, Methods and Data Systems
Investigations of global and related local phenomena on Mars such as atmospheric circulation patterns, boundary layer phenomena, water, dust and climatological cycles and investigations of the planetary interior would benefit from simultaneous, distributed in situ measurements. Practically, such an observation network would require low-mass landers, with a high packing density, so a large number of landers could be delivered to Mars with the minimum number of launchers.The Mars Network Lander (MetNet Lander; MNL), a small semi-hard lander/penetrator design with a payload mass fraction of approximately 17 %, has been developed, tested and prototyped. The MNL features an innovative Entry, Descent and Landing System (EDLS) that is based on inflatable structures. The EDLS is capable of decelerating the lander from interplanetary transfer trajectories down to a surface impact speed of 50–70 m s−1 with a deceleration of < 500 g for < 20 ms. The total mass of the prototype design is ≈ 24 kg, with ≈ 4 kg of mass available for the payload.The EDLS is designed to orient the penetrator for a vertical impact. As the payload bay will be embedded in the surface materials, the bay's temperature excursions will be much less than if it were fully exposed on the Martian surface, allowing a reduction in the amount of thermal insulation and savings on mass.The MNL is well suited for delivering meteorological and atmospheric instruments to the Martian surface. The payload concept also enables the use of other environmental instruments. The small size and low mass of a MNL makes it ideally suited for piggy-backing on larger spacecraft. MNLs are designed primarily for use as surface networks but could also be used as pathfinders for high-value landed missions.
Geomagnetic prospection is an efficient and environmentally friendly geophysical method for the analysis of the magnetic minerals’ distribution in the subsurface. High-resolution measurements require on-ground campaigns. However, these activities might imply high costs, risk and time consumption. Some more recent works have started to use magnetometers on-board remote piloted aircrafts. Normally, they fly at a constant altitude and use scalar probes. This configuration permits the determination of the magnitude of the magnetic field but not the direction, and requires advanced techniques for in-depth interpretation of the sources. In this manuscript, we describe the accommodation of a system for vector magnetometry in a drone whose flight altitude follows the elevation of the terrain. This singularity improves the capability of interpretation, including constraints in dating due to the record of the geomagnetic field. The work consists of the design, development and implementation of a solidary payload system anchored to the body of the platform in order to determine the vector magnetic field. It describes the details of the system and the performance characteristics obtained after the calibration, as well as its demonstration via a field campaign in the spatter deposits of Cerro Gordo volcano in Campos de Calatrava volcanic province in Spain.
19 May 2016 in Geoscientific Instrumentation, Methods and Data Systems
Satellite-based magnetic measurements of Mars indicate complex and very strong magnetic anomalies, which led to an intensive and long-lasting discussion about their possible origin. To make some progress in the investigation of the origin of these anomalies the MOURA vector magnetometer was developed for in situ measurements on Mars. In this work we propose the utilisation of such an instrument for future planetary on-ground surveys. The proof of its suitability is seen through testing it on various terrestrial analogues characterised by the distinct magnetic anomalies of their basement rocks: (1) a magnetite body of EL Laco (up to +110 000 nT) and its transition to surrounding andesites ( < +2000 nT) in the northern Andes of Chile showing the highest local magnetic anomalies. The magnetite-bearing ore body has highly variable local anomalies due to its complex formation history where a significant dispersion in palaeo-orientations has been previously reported, while our vector data show relatively uniform and probably induced declinations. (2) A basaltic spatter cone of the Pali Aike volcanic field, in southern Chile, was characterised by very strong magnetic anomalies along the crater rim (up to +12 000 nT), controlled by the amount of single domain magnetites in the ground mass of the basalts. Due to their strong remanent signature, palaeo-declinations of the lavas and reorientations of collapsed blocks could be constrained by the vector data. (3) The Monturaqui meteorite crater (350 m diameter), in northern Chile, shows significant variations of its anomalies (from −2000 to > +6000 nT) in restricted areas of several square metres along its crater rim related to unexposed iron-bearing fragments of the impactor while its granitic and ignimbritic target rocks exhibit only very weak anomalies. (4) An area with several amphibolitic dykes, which cross-cut a Cretaceous granitoid in the southernmost Andes, where a decimetre-scale mapping was performed. In this case, pyrrhotite is the only magnetic carrier. It was formed during hydrothermal processes within the dykes. Very low (+40 to +120 nT) positive magnetic anomalies clearly depict the amount of 1–4 vol % pyrrhotite in these dykes, which is important as a mineralogical indicator as well as to detect associated gold and copper enrichment.