Dynamic collapse behavior of a ship’s hull girder in waves is investigated; post-ultimate strength behavior is the focus. Firstly, a simulation method is proposed. Assuming that a plastic hinge is formed during the collapse of the hull girder, the whole ship is modeled as two rigid bodies connected amidship via a nonlinear rotational spring. The post-ultimate strength behavior, such as the reduction of load carrying capacity due to buckling and yielding, is reflected in the model. Hydrodynamic loads are evaluated by using nonlinear strip theory to account for the effect of large plastic deformations on the loads. A scaled model for validation of the simulation is designed and fabricated. Then a series of tank tests is conducted using the scaled model to validate the simulation results. Post-ultimate strength behavior characteristics in waves are clarified by using the numerical and tank test results. It is shown that the hull girder collapses rapidly after reaching ultimate strength, and then the plastic deformation grows until unloading starts at the collapsed section. Finally, several parametric dependencies of the extent of the collapse behavior are discussed based on a series of the simulations.

A series of experimental investigations on the post-ultimate strength collapse behaviour of a ship's hull girder under whipping loads are presented. It is a follow-up study of the authors based on numerical simulations. One of the important conclusions of the previous work is that given the same magnitude of the loads, the collapse extent is smaller for the loads with the shorter duration. For the validation, a scale model with a scale ratio 1/100, which follows a law of similitude in the ultimate bending strength as well as geometry is employed in tank tests. The whipping loads are produced by dropping a mass object. The time history of the whipping loads is pre-adjusted by tuning the object mass, cushion material and dropping height. The hull girder bending moment with a time duration ranging 0.5–1.5 s in real scale, however, with the same magnitude, is applied to the hull girder. It was observed that the collapse extent was smaller for the loads with the shorter duration.

A tank experiment using a flexible multi-column floating offshore wind turbine (FOWT) model in regular waves was carried out to clarify the floater elastic response and its influence on the floater motion. The model motion response from the experiment was compared with the numerical simulations by NK-UTWind and WAMIT codes. The dynamic elastic deformation of the model was also compared between the experiment and NK-UTWind. The experiment observed significant elastic deformation for the decks and columns of the model around the wave period corresponding to the natural period of the structural vibration. Furthermore, comparing the heave response amplitude operator (RAO) between experiments and numerical simulations, a small peak appeared around this period in the experiment and NK-UTWind simulation instead of WAMIT simulation. These results indicated that dynamic elastic deformation affected the heave response of the model. The change in the model rigidity revealed that such elastic deformation could affect the motion response statistics in an actual sea condition if the peak period of the onsite wave spectrum is close to the floater natural vibration period. These investigations indicated the importance of considering the elastic behavior of a FOWT at its design stage.

Three models with different footing types were used to clarify the effect of heave plates on the hydrodynamic behavior of the elastic response of a flexible multicolumn floating offshore wind turbine (FOWT). The models were tested under regular waves, whose added mass, damping, and motion response results were compared with numerical simulations by NK-UTWind and WAMIT codes. As a whole, the attachment of heave plates was responsible for increasing the added mass and damping levels, consequently modifying the RAO of the models. Regarding the response in a sea condition, a decrease of 33% and 66% of the significant motion height (heave and pitch) was observed. Thus, the heave plate can be a good feature for the future design of FOWT.