The purpose of this paper was to demonstrate the possibilities of assessing the reliability of oil and gas industry structures with the help of mathematical models of k-out-of-n systems. We show how the reliability of various structures in the oil and gas complex can be described and investigated using k-out-of-n models. Because the initial information about the life and repair time of components of systems is only usually known on the scale of one and/or two moments, we focus on the problem of the sensitivity analysis of the system reliability indices to the shape of its components repair time distributions. To address this problem, we used the so-called markovization method, based on the introduction of supplementary variables, to model the system behavior with the help of the two-dimensional Markov process with discrete-continuous states. On the basis of the forward Kolmogorov equations for the time-dependent process’ state probabilities, relevant balance equations for the process’ stationary probabilities are presented. Using these equations, stationary probabilities and some reliability indices for two examples from the oil and gas industry were calculated and their sensitivity to the system component’s repair time distributions was analyzed. Calculations show that under “rare” component failures, most system reliability indices become practically insensitive to the shape of the components repair time distributions.
We consider the identification problem for the technical parameters, i.e., hydraulic efficiency coefficients, of gas transmission systems (GTS) under standard unsteady gas flow. Coefficient estimation is reduced to a conditional optimization problem with equality type constraints. We propose an algorithm to solve it. The algorithm’s efficiency has been tested with computational experiments, including a looped gas supply system. The resulting model operates under the current level of GTS information support.
The paper is devoted to the modeling of unsteady gas flows in long pipelines. A widely used flow model in the form of a system of partial differential equations obtained by the methods of continuum mechanics is considered. The simplifying assumptions under which it is derived are discussed. It is stated that there is no experimental confirmation of the admissibility of these simplifications. Wave processes observed during the operation of the object are examined. The velocity of pressure waves propagation and attenuation was estimated, some physical phenomena, the causes of which are not clear from the available information, were identified. Actual observations are reconciled with the results of model calculations, some discrepancies between them are detected.