Most landslides in Korea are classified as shallow landslides with an average depth of less than 2 m. These shallow landslides are associated with the advance of a wetting front in the unsaturated soil due to rainfall infiltration, which results in an increase in water content and a reduction in the matric suction in the soil. Therefore, this study presents a modified equation of infinite slope stability analysis based on the concept of the saturation depth ratio to analyze the slope stability change associated with the rainfall on a slope. A rainfall infiltration test in unsaturated soil was performed using a column to develop an understanding of the effect of the saturation depth ratio following rainfall infiltration. The results indicated that the rainfall infiltration velocity due to the increase in rainfall in the soil layer was faster when the rainfall intensity increased. In addition, the rainfall infiltration velocity tends to decrease with increases in the unit weight of soil. The proposed model was applied to assess its feasibility and to develop a regional landslide susceptibility map using a geographic information system (GIS). For that purpose, spatial databases for input parameters were constructed and landslide locations were obtained. In order to validate the proposed approach, the results of the proposed approach were compared with the landslide inventory using a ROC (receiver operating characteristics) graph. In addition, the results of the proposed approach were compared with the previous approach used: a steady-state hydrological model. Consequently, the approach proposed in this study displayed satisfactory performance in classifying landslide susceptibility and showed better performance than the steady-state approach.
The aluminothermic process is used for producing ferrotitanium alloy (FeTi) from an ilmenite concentrate. In this study, based on thermodynamic calculations and experiments, we investigated the effects of adding varying amounts of exothermal agent (NaClO3), slag-forming agent (CaO), and reducing agent (Al) on the recovery ratio of Ti in the aluminothermic process. The thermodynamic calculations suggested that the exothermal agent plays a crucial role in producing the FeTi alloy from the ilmenite concentrate and the maximum Ti grade in the FeTi alloy was approximately 30 wt %. Experimentally, it was verified that the FeTi alloy obtained under the optimum mixing conditions contained 30.2–30.8 wt % Ti, 1.1–1.3 wt % Si, 9.5–11.2 wt % Al, and 56.9–58.0 wt % Fe, along with trace impurities and small amounts of gases such as oxygen (0.35–0.66 wt %) and nitrogen (0.01–0.02 wt %). At the optimum mixing conditions, the recovery ratio of Ti into the obtained FeTi alloy phase was 60.6–68.9%. These results matched closely with the thermodynamic calculations. Therefore, the thermodynamic calculations performed herein are expected to significantly contribute toward the development of new processes and improvement in conventional processes for producing various ferroalloys including the FeTi alloy through the aluminothermic process.
A reduced graphene oxide binder enhances the faradaic reaction kinetics of a Li 4 Ti 5 O 12 (anode) and the specific capacity of a porous activated carbon (cathode), resulting in properly balanced Li + -ion hybrid supercapacitors.