Supercritical CO2 power cycles have been deeply investigated in recent years. However, their potential in waste heat recovery is still largely unexplored. This paper presents a critical review of engineering background, technical challenges, and current advances of the s-CO2 cycle for waste heat recovery. Firstly, common barriers for the further promotion of waste heat recovery technology are discussed. Afterwards, the technical advantages of the s-CO2 cycle in solving the abovementioned problems are outlined by comparing several state-of-the-art thermodynamic cycles. On this basis, current research results in this field are reviewed for three main applications, namely the fuel cell, internal combustion engine, and gas turbine. For low temperature applications, the transcritical CO2 cycles can compete with other existing technologies, while supercritical CO2 cycles are more attractive for medium- and high temperature sources to replace steam Rankine cycles. Moreover, simple and regenerative configurations are more suitable for transcritical cycles, whereas various complex configurations have advantages for medium- and high temperature heat sources to form cogeneration system. Finally, from the viewpoints of in-depth research and engineering applications, several future development directions are put forward. This review hopes to promote the development of s-CO2 cycles for waste heat recovery.
6 November 2024 in Journal of Contemporary Educational Research
With the rapid development of science and technology and the transformation and upgrading of industry, new engineering construction has become the important direction of higher engineering education reform in our country. This research focuses on the “new engineering + curriculum ideological and political new form course construction path,” in order to meet the new requirements of talent training put forward by the development of new engineering. This paper analyzes the educational value and current situation of curriculum ideology and politics under the background of new engineering, and improves the ability of curriculum ideology and politics from the perspective of strengthening the teacher training system; optimizing curriculum ideological and political design, skillfully integrating into the ideological and political elements; and strengthening the cooperation between schools, enterprises, and family associations to enrich curriculum ideological and political resources. To build a collaborative education mechanism and form an all-round education pattern, the four aspects of the new engineering + curriculum ideological and political of the new form course construction path have been preliminarily explored, hoping to provide some references and guidance.
Carnot Batteries with thermal integration stand as one of the most promising approaches to tackling contemporary global energy problems. Currently, research on Carnot Battery systems utilizing the ocean thermal gradient is still in its early stages. This paper establishes a holistic thermo-economic model to assess the system’s performance. Through working fluid screening and subsequent multi-objective optimization, this study identifies the optimal working fluid and clarifies the system’s thermal economy at the optimal design point. With round-trip efficiency and total cost as metrics, a sensitivity analysis identified key parameter effects on the system. This was followed by a multi-objective optimization, where the TOPSIS method selected the optimal solution. It was found that, when Ammonia and R1234yf were used as the working fluids in the RC and ORC sub-cycles, respectively, the system can achieve peak performances of 71.79% round-trip efficiency and 36.24% exergy efficiency. Moreover, the RC evaporation temperature exerts the most significant influence on the overall thermodynamic performance. Multi-objective optimization successfully identified a balanced thermo-economic design, yielding an optimal solution with a round-trip efficiency of 65.30% at a total cost of USD 65.90 M. These results offer critical insights for the design and optimization of this promising ocean thermal-powered Carnot Battery system.
The regional imbalance of power supply and use is an important factor affecting the efficient and sustainable development of China’s power system. It is necessary to achieve the better matching of power supply and use through the optimization of the national power network layout. From a mathematical point of view, the power network layout’s optimization is a typical mixed-integer non-linear programming problem. The present paper proposes a novel method based on the Random Walk algorithm with Compulsive Evolution for China’s power network layout optimization to improve the network economy. In this method, the length of transmission lines and the amount of cross-regional power transmission between nodes are synchronously optimized. The proposed method was used to find the minimum total cost (TC) of the power transmission network on the basis of energy supply and use balance. The proposed method is applied to the optimization of power network of different scales. Results indicated that, compared with the optimization method that only optimizes the transmission line length, the TC of municipal and provincial power grids can be significantly reduced by the recommended methods. Moreover, for the national power network, through simultaneous optimization, the TC savings in 30 years of operation are significant.
10 February 2025 in Education Reform and Development
The rapid change of global climate and environmental deterioration and other factors make environmental problems increasingly prominent, to achieve “sustainable development and carbon neutrality” has become the focus of global hot discussion and the main goal. Based on this, strengthening environmental education and training is particularly key to the construction of engineering micro-majors in colleges and universities. Under the national dual-carbon development strategy of “carbon peak, carbon neutrality,” micro-majors focus on talent cultivation as the benchmark and become the best way to solve the employment difficulties of students and enterprises. There are still some problems in the construction of engineering micro-majors in colleges and universities. It is necessary to provide support through educational resources, talent cultivation and major construction to further enhance the enthusiasm of professional teachers to participate in discipline construction to help colleges and universities get rid of the dilemma of major construction through teaching mode construction based on the needs of industry, and help the sustainable development of micro-majors.