In order to enhance heat transfer in the abrasive-milling processes to reduce thermal damage, the concept of employing oscillating heat pipes (OHPs) in an abrasive-milling tool is proposed. A single-loop OHP (SLOHP) is positioned on the plane parallel to the rotational axis of the tool. In this case, centrifugal accelerations do not segregate the fluid between the evaporator and condenser. The experimental investigation is conducted to study the effects of centrifugal acceleration (0–738 m/s²), heat flux (9100–31,850 W/m²) and working fluids (methanol, acetone and water) on the thermal performance. Results show that the centrifugal acceleration has a positive influence on the thermal performance of the axial-rotating SLOHP when filled with acetone or methanol. As for water, with the increase of centrifugal acceleration, the heat transfer performance first increases and then decreases. The thermal performance enhances for higher heat flux rises for all the fluids. The flow inside the axial-rotating SLOHP is analyzed by a slow-motion visualization supported by the theoretical analysis. Based on the theoretical analysis, the rotation will increase the resistance for the vapor to penetrate through the liquid slugs to form an annular flow, which is verified by the visualization.

When grinding hard-to-machining materials such as titanium alloys, a massive grinding heat is generated and gathers in the grinding zone due to the low thermal conduction of the materials. The accumulated grinding heat easily leads to severe thermal damages to both the workpiece and the grinding wheel. A novel oscillating heat pipe (OHP) grinding wheel is one of the solutions to this phenomenon. The oscillating heat pipe grinding wheel can transfer the grinding heat directly from the grinding zone to avoid heat accumulation and a high temperature rise. In this paper, the temperature field of the grinding Ti-6Al-4V alloy is investigated, via the oscillating heat pipe grinding wheel, by numerical analysis. The three-dimensional thermal conduction model is built accordingly, containing the grinding wheel, grinding zone and Ti-6Al-4V workpiece. Due to the enhanced heat transport capacity of the oscillating heat pipe grinding wheel, the highest temperature in the grinding zone and the temperature on the ground surface of the workpiece decrease dramatically. For example, under a grinding heat flux of 1 × 10⁷ W/m², when using the grinding wheel without OHP and with OHPs, the highest temperature in the grinding zone drops from 917 °C to 285 °C by 68.7%, and the ground surface temperature decreases from 823 °C to 244 °C by 71.2%. Moreover, the temperature distribution on the grinding wheel is more uniform with an increase of the number of oscillating heat pipes.

Bone drilling is a common surgical operation, which often causes an increase in bone temperature. A temperature above 47 °C for 60 s is the critical temperature that can be allowed in bone drilling because of thermal bone osteonecrosis. Therefore, thermal management in bone drilling by a rotating heat pipe was proposed in this study. A new rotating heat pipe drill was designed, and its heat transfer mechanism and thermal management performance was investigated at occasions with different input heat flux and rotational speed. Results show that boiling and convection heat transfer occurred in the evaporator and film condensation appears in the condenser. The thermal resistance decreases with the increase of the rotational speed at the range from 1200 to 2000 rpm and it decreases as the input heat flux rises from 5000 to 10,000 W/m² and increases at 20,000 W/m². The temperature on the drill tip was found to be 46.9 °C with an input heat flux of 8000 W/m² and a rotational speed of 2000 rpm. The new designed rotating heat pipe drill showed a good prospect for application to bone drilling operations.