The system for stabilizing an operating point of remote integrated optical Mach–Zehnder modulators with a dual output has been developed. The designed electronic circuit for precise bias control had low power consumption (less than 5 mW) and could be powered through optical fiber by signal optical radiation at a wavelength of 1550 nm with a power of 15 mW. The experimental demonstration of common mode noise rejection proved a high accuracy of the quadrature operating point setting and stabilization, resistance to the light intensity noise, and low level noise and distortion added to the transmitted signals.
1 October 2019 in Journal of Physics: Conference Series
Phase noise spectra of the microwave spin-wave photonic generator were measured for various lengths of the optical fibres. Results show that the increase in fibre length from 200 m to 4 km reduces the phase noise tending to a limit value around -146.5 dBc/Hz at a 10-kHz offset from a generation frequency of 10 GHz.
A method to increase the transmission efficiency of an analog fiber-optic line using a shift of the working point of an external modulator toward minimum transmission is proposed. The method is based on an increase in the signal contrast owing to the suppression of the constant component and the application of an erbium-fiber amplifier in the near-saturation mode. An increase in the transmission (up to 5 dB) in comparison with the transmission corresponding to the quadrature working point is demonstrated. An increase in the nonlinear distortion factor due to the shift of the modulator from the quadrature working point is analyzed. An increase in the nonlinear distortions under the conditions for the maximum transmission is no greater than 0.5%. A theoretical model is developed to describe the experimental effects. The theoretical results are in good agreement with the experimental data.
12 September 2019 in Lecture Notes in Computer Science
A scheme of radio-technical control systems for determining the coordinates of radio-frequency radiation sources using elements of radio photonics is considered. The use of fiber-optic analog microwave transmission lines with an external modulator and direct signal detection made it possible to increase the base between the receiving points and enlarge the accuracy of bearing detection. The influence of the operating modes of an external modulator on the transmission coefficient of microwave signals from antennas to a radio receiver module is studied.
28 February 2020 in Journal of the Russian Universities. Radioelectronics
Introduction. Laser correlation spectroscopy is a promising method that allows one to analyze sizes of nanoparticles and to evaluate their shape and dynamics of aggregation in liquids. A limited usage of laser correlation spectroscopy is currently caused by insufficient accuracy of existing instruments and data processing algorithms. The paper described the development of laser correlation spectroscopic hardware complex designed for nanoparticles size determination in liquids. The basic requirements for the elements of the device and the approaches used to calculate the signal-to-noise ratio were discussed. The achieved parameters of the laser correlation spectrometer were presented.Aim. To develop the hardware for nanoparticles size determination in liquids and to optimize the parameters of hardware elements to increase signal-to-noise ratio.Materials and methods. Theory of dynamic light scattering to describe scattering of laser radiation in liquids was applied. Fundamental requirements for the elements of the laser correlation spectrometer were described.Results. An original scheme of the laser correlation spectrometer was developed, the basic requirements for the general scheme elements were described. Equations for calculating signal-to-noise ratio were given.Conclusion. The analysis of the main parameters of the elements of the laser correlation spectroscopic scheme were carried out. It helps one to evaluate the expected signal-to-noise ratio in laser correlation spectrometers.