A new apparatus is described that measures interparticle friction between sand-sized grains over relatively large displacements and also under immersion in a fluid. Its relatively simple design allows the key calibrations to be checked by statics. An analysis of the geometry of simple spherical particle contacts and the forces at those contacts revealed that there are strict constraints on the permissible stiffness of the interparticle friction apparatus to avoid stick–slip behaviour. Tests on ball bearings gave highly repeatable data, while others on glass ballotini revealed a significant effect of ambient humidity on the data obtained. The interparticle friction was found to increase with the roughness of the ballotini. Immersion in water increased the interparticle friction slightly for both the ballotini and quartz sand particles, while immersion in oil reduced the friction considerably for the quartz sand, especially at higher contact force levels.
Less research has been carried out on the changes induced by weathering to the mechanical properties of reconstituted and intact soils that originate from chemical decomposition of rocks (saprolites) than has been done for sedimentary soils. One-dimensional compression and triaxial tests were performed on reconstituted and intact specimens along a weathered profile to investigate the changes in their physical and mechanical properties. Some heterogeneity in the weathering tends to cloud the trends observed, but it was still clear that the grading varies the most, while the mineralogy changes less and the particle morphology is nearly unchanged. The gradient of the normal compression line is fairly constant with weathering, but reduces significantly at shallower depths. The gradient of the critical state line in the stress plane reduces with weathering, while its intercept in the volumetric plane has a more complex trend, but generally also reduces with decreasing depth. The value of the specific volume in situ increases with weathering and so the in situ state becomes closer to the critical state line. The effects of structure were quantified using a pseudo strength sensitivity defined by the location of the intact state boundary surface at the critical state. This parameter generally reduces with weathering and increases with depth.
Many advanced soil models rely on the current state relative to normal and critical state lines to describe soil behavior. The position of these lines, therefore, requires an accurate estimation of the specific volume or void ratio. A series of one-dimensional compression tests was performed both on a coarse and a fine grained soil to investigate the experimental accuracy of the initial specific volume. This was obtained comparing independent calculations of the initial specific volume that were based on redundant measurements of height and weight of the specimen, both at the beginning and at the end of the test. The redundancy in the measurements was a key factor to obtain independent calculations. It was found that the excess water, such as may be stored in the filter papers, was the main cause of inaccuracy, when gross errors did not occur. Two novel confining rings having a closed-base were designed to reduce this effect. Although this was possible for the coarse grained soils tested, the fine grained soils retained more water due to the higher suction at the end of the test and water adsorption could not be avoided. The assumption of saturation is shown to be far from accurate, meaning that both the bulk unit weight and the water content should be measured independently to obtain a reliable measurement of the specific volume. The specific volume of the intact soil was found to be less accurate than when reconstituted. The experimental scatter was compared with the theoretical accuracy obtained from the error propagation theory. Good agreement was found between the theoretical and experimental accuracy.