In the field of solar power generation, concentrator systems, such as concentrator photovoltaics (CPV) or concentrated solar power (CSP), are subject of intensive research activity, due to high efficiencies in electrical power generation compared to conventional photovoltaics (PV) and low-cost energy storage on the thermal side. Even though the idea of combining the thermal and electrical part in one absorber is obvious, very few hybrid systems (i.e., concentrator photovoltaics-thermal systems (CPV-T)) are either described in literature or commercially available. This paper features the conversion of a commercial thermal parabolic trough collector to a CPV-T hybrid system using multi-junction PV cells. The design process is described in detail starting with the selection of suitable PV cells, elaborating optical and mechanical system requirements, heat sink design and final assembly. Feasibility is proven by practical tests involving maximum power point tracking as well as empirical determination of heat generation and measurement results are presented.

The effects of global warming are severely recognizable and, according to the OECD, 47% of the world’s population will soon live in regions with insufficient drinking water. Already, many countries depend on desalination for fresh water supply, but such facilities are often powered by fossil fuels. This paper presents an energy self-sufficient desalination system that runs entirely on solar power. Sunlight is harvested using parabolic trough collectors with an effective aperture area of 1.5 m × 0.98 m and a theoretical concentration ratio of 150 suns, in which a concentrator photovoltaic thermal (CPV-T) hybrid-absorber converts the radiation to electricity and heat. This co-generated energy runs a multi-effect distillation (MED) plant, whereby the waste heat of multi-junction concentrator solar cells is used in the desalination process. This concept also takes advantage of synergy effects of optical elements (i.e., mirrors), resulting in a cost reduction of solar co-generation compared to the state of the art, while at the same time increasing the overall efficiency to ~75% (consisting of an electrical efficiency of 26.8% with a concurrent thermal efficiency of 48.8%). Key components such as the parabolic trough hybrid absorber were built and characterized by real-world tests. Finally, results of system simulations, including fresh water output depending on different weather conditions, degree of autonomy, required energy storage for off-grid operation etc. are presented. Simulation results revealed that it is possible to desalinate around 2,000,000 L of seawater per year with a 260 m² plant and 75 m³ of thermal storage.

Concentrator photovoltaics (CPVs) have demonstrated high electrical efficiencies and technological potential, especially when deployed in CPV–thermal (CPV-T) hybrid absorbers, in which the cells’ waste heat can be used to power industrial processes. However, the high cost of tracking systems and the predominant use of expensive multi-junction PV cells have caused the market of solar co-generation technologies to stall. This paper describes the development and testing of a low-cost alternative CPV cell based on crystalline silicone (c-Si) for use in a novel injection-molded parabolic hybrid solar collector, generating both, photovoltaic electricity and thermal power. The study covers two different c-Si cell technologies, namely, passive emitter rear contact (PERC) and aluminum back surface field (Al-BSF). Simulation design and manufacturing are described with special attention to fingerprinting in order to achieve high current carrying capacities for concentrated sunlight. It was determined that Al-BSF cells offer higher efficiencies than PERC for the considered use case. Solar simulator tests showed that the highly doped 4 cm² cells (50 ohm/sq) reach efficiencies of 16.9% under 1 sun and 13.1% under 60 suns at 25 °C with a temperature coefficient of −0.069%(Abs)/K. Finally, options to further improve the cells are discussed and an outlook is given for deployment in a field-testing prototype.