Ahmed El-Shafie

Dr. Ahmed El-Shafie

1Water Relations and Field Irrigation Department, National Research Centre, Cairo, Al Qāhirah, Egypt
orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications


2 September 2024 in Irrigation Science
Verified
Journal Article
Open access
PDF file
HHHaytham S. Helmy
Haytham S. Helmy
MAMohamed E. Abuarab
Mohamed E. Abuarab
EAEmad A. Abdeldaym
Emad A. Abdeldaym
SASuzy M. Abdelaziz
Suzy M. Abdelaziz
MAMarwa M. Abdelbaset
Marwa M. Abdelbaset
AMAli Mokhtar
Ali Mokhtar
Scientists, environmentalists, and farmers are currently in pursuit of sustainable agricultural practices that can effectively ensure global food security while simultaneously mitigating environmental degradation. A field experiment was conducted to elucidate the impact of low-cost capacitance soil moisture-based sensors on lettuce (Lactuca sativa L.) irrigation water conservation, agro-physiological aspects, and nutritional characteristics. The experiment also involved the use of five different types of soil mulching films: white geotextile (WGup), green geotextile (GGup), black plastic (BPup), white geotextile for both above and below ground (WGup-down), green geotextile for both above and below ground (GGup-down), in addition to un-mulched soil (control). The findings demonstrated that the application of WGup, BPup, WGup&down, and GGup&down resulted in a significant improvement in irrigation water conservation, with WGup exhibiting the highest savings at 41.86%, while the control group exhibited the least amount of water savings at 19.87%. Moreover, the highest productivity levels were observed in plants mulched with GGup&down, reaching 47,944.68 kg ha−1, whereas the lowest productivity was recorded in plants mulched with green geotextile GGup at 22,377.89 kg ha−1. In terms of irrigation water productivity (IWP), the order of effectiveness was BPup > GGup-down > WGup > WGup-down > GGup > Control, with BPup achieving the highest IWP at 60.19 kg m−3 and the control treatment reporting the lowest at 27.80 kg m−3. The percentage of the irrigation water applied for crop evapotranspiration (Irc) showed that the control treatment saved the least amount of irrigation water, saving only 19.87%, while the best treatment was WGup, achieved the highest percentage of irrigation water savings at 41.86%. Additionally, mulched plants exhibited higher levels of nutrients (N, P, Ca, Mg, Fe, Mn, and Zn), ascorbic acid (AsA), and total phenol content (TPC), while showing lower nitrate content in the leaves compared to non-mulched plants. Overall, the utilization of soil moisture-based capacitance sensors and biodegradable mulching films has proven to be highly effective and low cost by 16.633 US$ year−1 to enhance irrigation water productivity, growth performance, nutritional quality, and overall productivity of lettuce crops, thereby contributing to the sustainability of lettuce production in arid regions.

18 August 2023 in Acta Technologica Agriculturae
Verified
Journal Article
Open access
PDF file
AAAhmed Abdelhady
Ahmed Abdelhady
Mohamed Mahmoud IbrahimMohamed Mahmoud Ibrahim
Mohamed Mahmoud Ibrahim
Hani MansourHani Mansour
Hani Mansour
Ahmed El-ShafieAhmed El-Shafie
Ahmed El-Shafie
EREid Abd El Rahman
Eid Abd El Rahman
Manual harvesting of sugarcane requires skilled labourers, as improper harvesting leads to a significant loss of yield. Therefore, it is necessary to move towards designing a system capable of harvesting sugarcane on smallholdings, with high harvesting efficiency. This study aims to determine some physico-mechanical properties of sugarcane stalks related to harvester by making a comprehensive analysis of the compressing, bending, and shearing properties of sugarcane stalks. These properties were measured at three moisture content levels at three positions (base, middle, and top) of the stalk with three sugarcane varieties (G.T.54-9, IK 76-66, and HAO3-55-24). The different moisture contents were fresh stalk, after 7 days, and after 15 days. The values of different content with different varieties were (70.3, 42.1, and 23.2%), (68.7, 61.3, and 42.7%) and (66.4, 48.6, and 30.5%), respectively. The physico-mechanical properties of stalks were measured in terms of diameter, length, fresh mass, moisture content, sugarcane stalk bulk density, compression stress, shear stress and bending stress at three different positions (top, middle, and base).The most important results showed that the decreasing stalk moisture content of three sugarcane varieties led to an increase in compression, shear, and bending stresses.

9 June 2021 in Journal of Water and Land Development
Verified
Journal Article
Closed access
ODOsama Moawad Dewedar
Osama Moawad Dewedar
FPFinn Lars Plauborg
Finn Lars Plauborg
Ahmed El-ShafieAhmed El-Shafie
Ahmed El-Shafie
MAMarwa Abdelbasit
Marwa Abdelbasit
FAO AquaCrop model ver. 6.1 was calibrated and validated by means of an independent data sets during the harvesting seasons of 2016/2017 and 2017/2018, at El Noubaria site in western north of Egypt. To assess the impact of the increase in temperature and CO2 concentration on potato biomass and tuber yield simulations, experiments were carried out with four downscaled and bias-corrected of General Circulation Models (GCMs) data sets based on the fifth phase of the Coupled Model Intercomparison Project (CMIP5) scenarios under demonstrative Concentration Trails (RCPs) 4.5 and 8.5, selected for 2021–2040 and 2041–2060. The study showed that the model could satisfactorily simulate potato canopy cover, biomass, harvest and soil water content under various irrigation treatments. The biomass and yield decreased for all GCMs in both future series 2030s and 2050s. Biomass reduction varied between 5.60 and 9.95%, while the reduction of the simulated yield varied between 3.53 and 7.96% for 2030. The lowest values of biomass and yield were achieved by HadGEM2-ES under RCP 8.5 with 27.213 and 20.409 Mg∙ha–1, respectively corresponding to –9.95 and –7.96% reduction. The lowest reductions were 5.60 and 3.53% for biomass and yield, respectively, obtained with MIROC5 under RCP 8.5 for 2030. Reductions in biomass and yield in 2050 were higher than in 2030. The results are showing that higher temperatures shortened the growing period based on calculated growing degree days (GDD). Therefore, it is very important to study changing sowing dates to alleviate the impact of climate change by using field trials, simulation and deep learning models.

2 March 2023 in Agriculture
Verified
Journal Article
Open access
PDF file
EYEbtessam Youssef
Ebtessam Youssef
MAMarwa Abdelbasit
Marwa Abdelbasit
ODOsama Moawad Dewedar
Osama Moawad Dewedar
José Miguel Molina MartínezJosé Miguel Molina Martínez
José Miguel Molina Martínez
Ahmed El-ShafieAhmed El-Shafie
Ahmed El-Shafie
Understanding the anticipated impact of climate change on agriculture, as well as water conservation, is critical to achieving food security. Therefore, during this critical time and due to reduced water resources and increased food demand, it is important to study the impact of water-stress conditions on crops. Two successive seasons were carried out through the 2021 and 2022 seasons to estimate the crop coefficient (Kc) and study the effect of abscisic acid on red cabbage plants (Brassica oleracea var. capitata) under water-stress conditions at a private farm in the Bilbeis region, Sharqia Governorate, Egypt. The aim was to estimate the crop coefficient (Kc) and effect of different concentrations of abscisic acid (ABA) (0, 25, 50, and 75 ppm) under various irrigation levels (100, 80, and 60% of field capacity “FC”) on the growth process and yield parameters of red cabbage plants. The results revealed that the average estimated crop coefficient (Kc) for red cabbage crops under standard conditions, 100% of FC, was 0.75, 1.07, 1.2 and 0.88 and 0.77, 1.2, 1.25 and 0.82 for Initial, Development, Mid, and End stages during the 2021 and 2022 growing seasons, respectively. Data collected during both seasons clearly showed that all treatments significantly increased both the plant’s growth process and yield parameters when compared to the control. However, abscisic acid (ABA, 75 ppm) application with irrigation requirements (80% of FC) was statistically the most effective treatment in this study. Hence, this means a water savings of 20% can be achieved without significantly compromising the yield.