Spray products based on Bacillus thuringiensis (Bt) (Berliner) (Bacillales: Bacillaceae) are widely used as control agents of the fall armyworm, Spodoptera frugiperda (J.E. Smith) (Lepidoptera: Noctuidae), in some major crops such as corn, cotton, and soy. However, there is little information about the toxicity of Bt formulations to control corn and rice-infesting S. frugiperda strains. These S. frugiperda strains are morphologically indistinguishable, so they are genetically identified as corn and rice S. frugiperda strains. The main objective of this study was to evaluate the susceptibility of third instar larvae of both S. frugiperda biotypes to either the native Bt RT or the reference Bt HD1 subsp. kurstaki (Btk) formulations. In addition, the S. frugiperda populations were characterized by their esterase profile in polyacrylamide gels. This study also allowed differentiation of the S. frugiperda strains. Concerning the susceptibility assays, a significant difference in mortality values was found within some corn or rice S. frugiperda colonies when Bt RT treatment was used, whereas there were no significant differences in Btk HD1 toxicity within colonies that share the same biotype. When toxicity of either the native Bt RT or the reference Btk HD1 to each S. frugiperda biotype was compared, significant differences in mortality values also were found in the corn and the rice S. frugiperda strains. Finally, the statistical analysis of the mortality data revealed that there was a significant difference between the 2 S. frugiperda strains, regardless of the Bt preparation. These results show that the S. frugiperda control could depend not only on the bioinsecticide used, but also on the S. frugiperda biotype being treated.
The insecticidal crystal proteins produced by Bacillus thuringiensis during sporulation are active ingredients against lepidopteran, dipteran, and coleopteran insects. Several methods have been reported for their quantification such as crystals counting, ELISA, and SDS-PAGE/densitometry. One of the major tasks in industrial processes is the analysis of raw materials dependency and costs. Thus, the crystal proteins quantification method is expected to be compatible with the presence of complex and inexpensive culture medium components. This work presents a revalidated elution-based method for the quantification of insecticidal crystal proteins produced by the native strain B. thuringiensis RT. To quantify proteins, a calibration curve was generated by varying the amount of BSA loaded into SDS-PAGE gels. Firstly, SDS-PAGE was performed for quality control of the bioinsecticide. Then, the stained protein band was excised from 10% polyacrylamide gel and the protein-associated dye was eluted with an alcoholic solution of SDS (3% SDS in 50% isopropanol) during 45 min at 95°C. This protocol was a sensitive procedure to quantify proteins in the range of 2.0–10.0 µg. As proof of concept, proteins of samples obtained from a complex fermented broth were separated by SDS-PAGE. Then, Cry1 and Cry2 proteins were properly quantified.