This study explores the influence of land-use and land cover (LULC) changes on the temperature over North India (NI) and North-Eastern India (NEI) during 1981–2006 by subtracting the reanalysis temperature from the observed temperature (observation minus reanalysis (OMR) method). The normalized difference vegetation index (NDVI) data of the AVHRR satellite for the period 1981–2006 were analyzed to understand the type of LULC changes during this period and their linkage with the temperature change over the two regions. The results from OMR indicated that the LULC change over NI during 1981–2006 resulted a warming of 0.03 °C, and that of NEI during this period resulted a cooling of 1.5 °C. The results from LULC changes during the said period indicated an increase of dry land/snow cover and agriculture/fallow land by ~0.1% of total area and a decrease of shrubs/small vegetation and dense forest over NI by about 0.1–0.2%. Over NEI, the areas under agricultural/fallow land, open forest and dense forest showed an increase by about 0.8–2.4% during this period, and the areas under dry/snow cover and shrubs/small vegetation indicated a decrease by ~0.7–3.6%. The comparison between the OMR analysis and LULC changes indicated that the warming over NI during 1981–2006 is due to the expansion of the dry land and the decline of dense forest. On the other hand, the cooling over NEI during the period is attributed to the decline of non-vegetated/small vegetated lands and the expansion of agricultural land/forest covers in that period. This study has an overall implication towards the modeling studies for the impact assessment of LULC changes in the present as well as future climate.
The study investigates the influence of near-surface atmospheric parameters on land surface processes at the land–atmosphere interface through the offline simulation of the 2D Noah Land Surface Model-based High-Resolution Land Data Assimilation System (HRLDAS). The HRLDAS is used to conduct sensitive experiments by introducing perturbation in the atmospheric parameters, and the experiments were conducted for the period 2011–2013 in India. In each sensitive experiment, a single parameter is perturbed at a time, keeping the rest of the forcing parameters unchanged, and the procedure is followed for all the forcing parameters. The results revealed that the downward longwave radiation and T2 are highly sensitive to land surface processes, while wind speed is the least sensitive. The land surface process sensitivity varies with soil moisture content. The annual mean soil moisture at the surface layer is increased (decreased) by 8% when long wave radiation is decreased (increased) by 20%. Similarly, the annual mean soil temperature increased (decreased) by 2.2 °C when T2 increased (decreased) by 1%. The latent heat flux is highly sensitive to longwave radiation over the wetter soil, while its sensitivity to rainfall is higher over the drier soil. This is attributed to evapotranspiration’s sensitivity to the preferred soil moisture state. Further, the land surface sensitivity varies with contrasting seasons. The sensitivity of soil moisture and latent heat flux is high in OND and JJA seasons, respectively, and are least sensitive in the MAM season. In contrast, the sensible heat flux is highly sensitive to solar radiation in the MAM season and comparatively less sensitive in the JJA season. The study suggests that the antecedent soil moisture state plays a critical role in modulating land surface process sensitivity, and, therefore, a realistic soil moisture state is important for land surface feedback processes.
The prediction of extremely severe cyclonic storms has been a long-standing and challenging issue due to their short life period and large variation in intensities over a short time. In this study, we predict the track, intensity, and structure of an extremely severe cyclonic storm (ESCS) named ‘Fani,’ which developed over the Bay of Bengal region from 27 April to 4 May 2019, using the Advanced Research version of the Weather Research and Forecasting (WRF-ARW) model. Two numerical experiments were conducted using the moving nested domain method with a 3 km horizontal resolution, one with the FLUX-1 air-sea flux parameterization scheme and the other with the FLUX-2 air-sea flux parameterization scheme. The NCEP operational Global Forecast System (GFS) analysis and forecast datasets with a 25 km horizontal resolution were used to derive the initial and boundary conditions. The WRF model’s predicted track and intensity were validated with the best-fit track dataset from the India Meteorological Department (IMD), and the structure was validated with different observations. The results showed that the WRF model with the FLUX-1 air-sea parameterization scheme accurately predicted the track, landfall (position and time), and intensity (minimum sea level pressure and maximum surface wind) of the storm. The track errors on days 1 to 4 were approximately 47 km, 123 km, 96 km, and 27 km in the FLUX-1 experiment and approximately 54 km, 142 km, 152 km, and 166 km in the FLUX-2 experiment, respectively. The intensity was better predicted in the FLUX-1 experiment during the first 60 h, while it was better predicted in the FLUX-2 experiment for the remaining period. The structure, in terms of relative humidity, water vapor, maximum reflectivity, and temperature anomaly of the storm, was also discussed and compared with available satellite and Doppler Weather Radar observations.
Soil moisture is one of the key components of land surface processes and a potential source of atmospheric predictability that has received little attention in regional scale studies. In this study, an attempt was made to investigate the impact of soil moisture on Indian summer monsoon simulation using a regional model. We conducted seasonal simulations using a regional climate model (RegCM4) for two different years, viz., 2002 (deficit) and 2011 (normal). The model was forced to initialize with the high-resolution satellite-derived soil moisture data obtained from the Climate Change Initiative (CCI) of the European Space Agency (ESA) by replacing the default static soil moisture. Simulated results were validated against high-resolution surface temperature and rainfall analysis datasets from the India Meteorology Department (IMD). Careful examination revealed significant advancement in the RegCM4 simulation when initialized with soil moisture data from ESA-CCI despite having regional biases. In general, the model exhibited slightly higher soil moisture than observation, RegCM4 with ESA setup showed lower soil moisture than the default one. Model ability was relatively better in capturing surface temperature distribution when initialized with high-resolution soil moisture data. Rainfall biases over India and homogeneous regions were significantly improved with the use of ESA-CCI soil moisture data. Several statistical measures such as temporal correlation, standard deviation, equitable threat score (ETS), etc. were also employed for the assessment. ETS values were found to be better in 2011 and higher in the simulation with the ESA setup. However, RegCM4 was still unable to enhance its ability in simulating temporal variation of rainfall adequately. Although initializing with the soil moisture data from the satellite performed relatively better in a normal monsoon year (2011) but had limitations in simulating different epochs of monsoon in an extreme year (2002). Thus, the study concluded that the simulation of the Indian summer monsoon was improved by using RegCM4 initialized with high-resolution satellite soil moisture data although having limitations in predicting temporal variability. The study suggests that soil moisture initialization has a critical impact on the accurate prediction of atmospheric circulation processes and convective rainfall activity.
Urban areas experience significant alterations in their local surface energy balance due to changes in the thermal properties of impervious surfaces, albedo, land use, and land cover. In addition, the embedded influence of urbanization and heat-trapping in the urban canopy cause city temperature warmer compared to its surroundings peri-urban regions. However, the influence of urbanization on winter surface temperatures remains unclear. In this study, the urbanization influence on winter surface temperature in Bhubaneswar, a tropical two-tier city in India, is assessed using a high-resolution (4 km × 4 km) urban canopy model coupled with the Weather Research and Forecasting model. Numerical experiments are conducted with no urban coupling (CTL) and with coupling of a single-layer urban canopy model (UCM) for the winters of 2004 and 2015. The study suggests that both model simulations exhibit a similar warm bias in mean surface temperature (~ 2.2 °C), but UCM’s surface temperature better agrees with the observations compared to CTL. The warm bias in both experiments is primarily contributed by a higher nighttime warm bias (~ 3.2 °C). The study reveals that urbanization contributes to ~ 0.4 °C increase in surface temperature in 2015, especially in the eastern lowland regions of the city, while the impact is minimal in 2004. In the western region, the influence is nullified, possibly due to lower surface specific humidity affecting longwave radiation in a higher terrain setting. This study underscores the significance of terrain and local microclimate conditions in shaping winter urban surface temperatures, shedding light on the complex interplay between urbanization and climate.
This study performed a land use and land cover (LULC) change analysis over Southern India for the period 1981–2006 from the normalized difference vegetation index (NDVI) images of AVHRR data and applied the “observation minus reanalysis” (OMR) method to investigate the impact of the LULC change on the temperature of the region. The LULC change analysis indicated that the areas under agriculture/fallow land were significantly increased while the areas under shrubs/small vegetation were decreased during the period 1981–2006. The areas under forest cover and barren land were also decreased but relatively low compared to the other LULC types. The OMR results showed that the LULC changes over urban areas contributed to warming with a temperature of 0.02 °C during this period, while that over non-urban areas showed a cooling effect with a temperature reduction of 0.29 °C and that over the whole Southern India (looked at an average) indicated a cooling effect with a temperature reduction of 0.063 °C. The comparative analysis between the two (LULC change analysis and OMR) results showed that the cooling over Southern India was mostly due to the expansion of agriculture/fallow land and the decline of shrubs/small vegetation. The study suggests that the OMR method reasonably demonstrates the effect of LULC changes on the temperature over Southern India.