Glass fibres with silicon cores have emerged as a versatile platform for all-optical processing, sensing and microscale optoelectronic devices. Using SiGe in the core extends the accessible wavelength range and potential optical functionality because the bandgap and optical properties can be tuned by changing the composition. However, silicon and germanium segregate unevenly during non-equilibrium solidification, presenting new fabrication challenges, and requiring detailed studies of the alloy crystallization dynamics in the fibre geometry. We report the fabrication of SiGe-core optical fibres, and the use of CO2 laser irradiation to heat the glass cladding and recrystallize the core, improving optical transmission. We observe the ramifications of the classic models of solidification at the microscale, and demonstrate suppression of constitutional undercooling at high solidification velocities. Tailoring the recrystallization conditions allows formation of long single crystals with uniform composition, as well as fabrication of compositional microstructures, such as gratings, within the fibre core.
Optimizing the morphology of bulk heterojunctions is known to significantly improve the photovoltaic performance of organic solar cells, but available quantitative imaging techniques are few and have severe limitations. We demonstrate X-ray ptychographic coherent diffractive imaging applied to all-organic blends. Specifically, the phase-separated morphology in bulk heterojunction photoactive layers for organic solar cells, prepared from a 50:50 blend of poly(3-hexylthiophene) (P3HT) and phenyl-C61-butyric acid methyl ester (PCBM) and thermally treated for different annealing times is imaged to high resolution. Moreover, using a fast-scanning calorimetry chip setup, the nano-morphological changes caused by repeated thermal annealing applied to the same sample could be monitored. X-ray ptychography resolves to better than 100 nm the phase-segregated domains of electron donor and electron acceptor materials over a large field of view within the active layers. The quantitative phase contrast images further allow us to estimate the local volume fraction of PCBM across the photovoltaically active layers. The volume fraction gradient for different regions provides insight on the PCBM diffusion across the depletion zone surrounding PCBM aggregates. Phase contrast X-ray microscopy is under rapid development, and the results presented here are promising for future studies of organic-organic blends, also under in situ conditions, e.g., for monitoring the structural stability during UV-Vis irradiation.
We report analysis of electrospun polymer nanofibers fabricated from blends of semicrystalline polyamide-6 (PA-6) and fully amorphous polyamide-6 (PA-6I) in the narrow diameter range of 200–250 nm. The combined differential scanning calorimetry and wide angle x-ray scattering results show the presence of α- and γ-phase crystals in PA-6 nanofibers. Simultaneous small- and wide-angle x-ray scattering investigations confirmed the existence of small elongated domains which were formed during the electrospinning process due to stretching of polymer chains. The Debye–Bueche analysis determined a cross-sectional width of elongated domains in the range of 10.8–16 Å. Additionally, analysis by Ruland's method revealed a decrease in the length of elongated domains with increasing crystalline phase content in the blends. Evaluation of Herman's orientation function suggested that the domains possessed higher molecular anisotropy along the c-axis in PA-6I compared to PA-6 nanofibers. These investigations and the suggested role of the amorphous phase in molecular stretching of polymer chains in electrospun nanofibers, may have broad implications for the size-dependent mechanical properties.