Characterization of residual stress in bulk crystals is of vital importance since it can provide abundant information on the crystal growth and process techniques. In this paper, the residual stress in 4H-SiC bulk crystals was investigated by neutron diffraction. Detailed strain and stress calculations were performed using the Bragg equation and Hooke's law. The (0004), (11−20) and (1−100) plane diffraction profiles were measured. The strain and stress in three directions were found to be on the order of 10−4–10−3 and 100–1000 MPa, respectively. Moreover, the stress distributions in different directions were anisotropic. Amongst the stresses in these three directions, the stresses in the direction were tensile and the maximum value was up to 2953 MPa, which indicated that there was a high risk of the grown crystals cracking in this direction.
Co-catalyst deposition is used to improve the surface and electrical properties of photocatalysts. In this work, MoSx/CdIn2S4 nanocomposites were prepared by a facile hydrothermal and photodeposition route. The basic crystalline phases and morphology of the as-prepared samples were determined, and these results showed that MoSx was tightly anchored onto CdIn2S4 by sharing the same S atom. In the hydrogen production experiments, MoSx/CdIn2S4-40 displayed the optimal photocatalytic hydrogen production yield in 4 h. The H2 evolution rate reached 2846.73 μmol/g/h, which was 13.6-times higher than that of pure CdIn2S4. Analyzing the photocatalytic enhancement mechanisms revealed that this unique structure had a remarkable photogenerated electron-hole pair separation efficiency, rapid charge carrier transfer channels, and more abundant surface reaction sites. The use of co-catalyst (MoSx) greatly improved the photocatalytic activity of CdIn2S4.
In this study, a novel Al doping method was used to grow p-type SiC. p-Type 4H-SiC crystals were grown by a physical vapor transport (PVT) method using p-type SiC powder.
Micropipe, a “killer” defect in SiC crystals, severely hampers the outstanding performance of SiC-based devices. In this paper, the etching behavior of micropipes in 4H-SiC and 6H-SiC wafers was studied using the molten KOH etching method. The spectra of 4H-SiC and 6H-SiC crystals containing micropipes were examined using Raman scattering. A new Raman peak accompanying micropipes located near −784 cm−1 was observed, which may have been induced by polymorphic transformation during the etching process in the area of micropipe etch pits. This feature may provide a new way to distinguish micropipes from other defects. In addition, the preferable etching conditions for distinguishing micropipes from threading screw dislocations (TSDs) was determined using laser confocal microscopy, scanning electron microscopy (SEM) and optical microscopy. Meanwhile, the micropipe etching pits were classified into two types based on their morphology and formation mechanism.