One of the biggest challenges in microscale additive manufacturing is the production of three-dimensional, microscale metal parts with a high enough throughput to be relevant for commercial applications. This paper presents a new microscale additive manufacturing process called microscale selective laser sintering (μ-SLS) that can produce true 3D metal parts with sub-5 μm resolution and a throughput of greater than 60 mm³/hour. In μ-SLS, a layer of metal nanoparticle ink is first coated onto a substrate using a slot die coating system. The ink is then dried to produce a uniform nanoparticle layer. Next, the substrate is precisely positioned under an optical subsystem using a set of coarse and fine nanopositioning stages. In the optical subsystem, laser light that has been patterned using a digital micromirror array is used to heat and sinter the nanoparticles into the desired patterns. This set of steps is then repeated to build up each layer of the 3D part in the μ-SLS system. Overall, this new technology offers the potential to overcome many of the current limitations in microscale additive manufacturing of metals and become an important process in microelectronics packaging applications.

A high electrical and thermal conductivity coupled with low costs make copper (Cu) an enticing alternative to aluminum for the fabrication of interconnects in packaging applications. To tap into the benefits of the ever-reducing size of transistors, it is required to increase the input/output pin count on electronic chips, and thus, minimize the size of chip to board interconnects. Laser sintering of Cu nanoparticle (NP) inks can serve as a promising process for developing these micron sized, 3D interconnect structures. However, the exact processing windows for Cu NP sintering are not well known. Therefore, this paper presents an extensive experimental investigation of the sintering processing window with different lasers including femtosecond (fs), nanosecond (ns), and continuous-wave (CW) lasers. The dependence of the processing window on Cu layer thicknesses and laser exposure durations has also been investigated. A simplified model to estimate optimum laser sintering windows for Cu NPs using pulsed lasers is presented and the predicted estimates are compared against the experimental results. Given the simplicity of the model, it is shown to provide good estimates for fluence required for the onset of sintering and the processing window for good sintering of Cu NPs.

Previously unmeasurable mechanical properties of additively manufactured polymer nanowires were measured using custom-built MEMS sensors to characterize the process–property relationship.