Hydrogen sulfide (H2S) is a hazardous, colorless, flammable gas with a distinct rotten-egg smell at low concentration. Exposure to a concentration greater than 500 ppm of H2S can result in irreversible health problems and death within minutes. Because of these hazards, operations such as oil and gas processing and sewage treatment that handle or produce H2S and/or sour gas require effective and well-designed hazard controls, as well as state-of-the-art gas monitoring/detection mechanisms for the safety of workers and the public. Laboratories studying H2S for improved understanding must also develop and continually improve upon lab-specific safety standards with unique detection systems. In this study, we discuss various H2S detection methods and hazard control strategies. Also, we share our experience regarding a leak that occurred as a result of the failure of a perfluoroelastomer O-ring seal on a small stirred autoclave vessel used for studying H2S hydrate dissociation/formation conditions in our laboratory, and discuss how our emergency response plan was activated to mitigate the risk of exposure to the researchers and public.
1 October 2020 in International Journal of Greenhouse Gas Control
In order to prevent solids from forming during the transportation and handling of liquid propane, C3H8(l), the fluid is dehydrated to a level below the water dew point concentration for the coldest operating temperature. Thus, accurate calculation of the saturation water content for C3H8 is important to determine the designed allowable concentration in liquid C3H8. In this work, we measured the water content of liquid C3H8 in the presence of the structure II hydrate from p = 1.081 to 40.064 MPa and T = 241.95 to 276.11 K using a tunable diode absorption spectroscopy technique. The water content results were modelled using the reference quality reduced Helmholtz equations and the Sloan et al. model for the non-hydrate and hydrate phases, respectively. Calculations show a good agreement (an average difference of less than 12 ppm) when compared to our measurements. Furthermore, the model was also used for calculating the dissociation temperatures for three phase loci, where a relative difference greater than 5 K was observed compared to the literature, hence our previously model reported by Adeniyi et al. is recommended for three phase loci calculations.