This study experimentally investigated process mechanisms and characteristics of newly developed xenon flash lamp lift-off (XF-LO) technology, a novel thin film lift-off method using a light to heat conversion layer (LTHC) and a xenon flash lamp (XFL). XF-LO technology was used to lift-off polyimide (PI) films of 8.68–19.6 μm thickness. When XFL energy irradiated to the LTHC was 2.61 J/cm2, the PI film was completely released from the carrier substrate. However, as the energy intensity of the XFL increased, it became increasingly difficult to completely release the PI film from the carrier substrate. Using thermal gravimetric analysis (TGA), Fourier-transform infrared spectroscopy (FTIR) and transmittance analysis, the process mechanism of XF-LO technology was investigated. Thermal durability of the PI film was found to deteriorate with increasing XFL energy intensity, resulting in structural deformation and increased roughness of the PI film surface. The optimum energy intensity of 2.61 J/cm2 or less was found to be effective for performing XF-LO technology. This study provides an attractive method for manufacturing flexible electronic boards outside the framework of existing laser lift-off (LLO) technology.
We implemented ultra-high resolution patterns of 2822 pixels-per-inch (PPI) via an inkjet printing and vacuum drying process grafted onto a sublimation transfer process. Co-solvented ink with a 1:1 ratio of N,N-dimethylformamide (DMF) to ortho-dichlrorobenzene (oDCB) was used, and the inkjet driving waveform was optimized via analysis of Ohnesorge (Oh)—Reynolds (Re) numbers. Inkjet printing conditions on the donor substrate with 2822 PPI microchannels were investigated in detail according to the drop space and line space. Most sublimation transferred patterns have porous surfaces under drying conditions in an air atmosphere. Unlike the spin-coating process, the drying process of inkjet-printed films on the microchannel has a great effect on the sublimation of transferred thin film. Therefore, to control the morphology, we carefully investigated the drying process of the inkjet-printed inks in the microchannel. Using a vacuum drying process to control the morphology of inkjet-printed films, line patterns of 2822 PPI resolution having a root-mean-square (RMS) roughness of 1.331 nm without voids were successfully fabricated.
We investigated co-solvented solution properties and relations in the sublimation transfer process and optimized intense pulse light (IPL) using time-of-flight secondary ion mass spectrometry (ToF-SIMS) analysis. The capillary force induced co-solvented solution into the microchannel, with the co-solvented solution properties influencing the thickness and morphology of the sublimation transferred patterns of the emitting layer. The sublimation transferred pattern was optimized by tuning the ratio of solvents that were mixtures of chlorobenzene and ortho-dichlorobenzene. In addition, an analysis of the interface between pre-deposited layers and the evaporated layer fabricated by variation of IPL energy was conducted by means of ToF-SIMS depth profiling. Host emissions or the occurrence of the intermixing of layers was detected due to insufficient or excessive IPL energy exposure. With the optimized IPL energy, the current efficiency and external quantum efficiency were maximized without a recombination zone shift or intermixing during the IPL evaporation process.