The shortage of fresh water creates acute challenges in the West Bank of Palestine. Springs provide a main water resource in the West Bank. Investigating springs’ water quality is essential step for promoting their public use. The aim of this research is to assess the microbiological and physiochemical quality parameters of drinking water from springs. The study methodology included sampling through field work and laboratory testing for water quality parameters using standard procedures. The study area covered all locations containing licensed springs by the Palestinian Water Authority in the West Bank of Palestine. The number of collected samples was 127 covering 300 springs. The chemical, physical, and biological parameters for each sample were measured. Then, the obtained characteristics were evaluated based on national and international quality standards (PSI and WHO). The investigated parameters included temperature, pH, EC, total hardness, concentrations of nitrate, sodium ions, total chlorine, residual chlorine, turbidity, and total and faecal coliforms. Most of investigated physical and chemical parameters were within the acceptable standard limits. However, the turbidity and chloride and nitrate concentrations exceeded standard limits. The findings indicate that only a minor fraction of the samples (2%) requires chlorination treatment, while most of the springs (97% of samples) are classified as possessing no risk.
The main aim of this study was to perform a parametric study for treating a model dye containing wastewater (i.e., methylene blue, MB) using locally available biomass wastes in Palestine as the adsorbent. Eight different types of biomasses were investigated in batch adsorption tests, including coffee grains, almond shells, pistachio shells, date pits, jute sticks, sunflower shells, peanut shells, and grapevine sticks. The experiments were conducted on three different phases of processing for these materials: as natural adsorbents, biochar, and activated carbon. The biochar was prepared by pyrolysis, while ZnCl2 was used to chemically activate the materials for obtaining activated carbon. The influences of pH, initial MB concentration, and adsorbent dosage on the adsorption capacity and kinetics were investigated for activated carbon obtained from sunflower shells. The results indicate that the adsorption efficiency of natural adsorbents and biochar is highly dependent on the biomass type. As a natural adsorbent, peanut hulls demonstrated the maximum efficiency (>95%) for removing MB, whereas date pits showed the lowest efficiency (20%). In terms of biochar, jute sticks provide the highest removal efficiency. After activation with ZnCl2, a considerable increase in their adsorption efficiency (>95%) was obtained for most of the adsorbents, with sunflower shells being the most efficient adsorbent. The results confirm the technical feasibility of the adsorption technology to treat dye containing wastewater using locally available biomass wastes.