Jerzy Weremczuk

Dr. Jerzy Weremczuk

Warsaw University of Technology, Faculty of Electronics and Information Technology, Institute of Electronic Systems
orcid

Research Focus & Metrics

Academic Career Length

27Years (2000-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2012 in Procedia Engineering
Verified
Journal Article
Open access
JWJerzy Weremczuk
Jerzy Weremczuk
GTGrzegorz Tarapata
Grzegorz Tarapata
RJRyszard Jachowicz
Ryszard Jachowicz
The paper presents a humidity sensor which was directly printed on textile using the ink-jet printing technology. Fabricated sensors were tested in a controlled environment at 25°C and 5-95% of RH. The measured impedance modulus versus humidity for the Nafion sensitive layer shows a non-linear distribution over the range from 40 to 95% of RH with dependence on measurement frequency. Obtained results show sensor potential for gas humidity monitoring as integrated sensors with “smart” textiles

5 December 2011 in Measurement Science and Technology
Verified
Journal Article
Closed access
JWJerzy Weremczuk
Jerzy Weremczuk
GTGrzegorz Tarapata
Grzegorz Tarapata
RJRyszard S Jachowicz
Ryszard S Jachowicz

21 November 2010 in Microsystem Technologies
Verified
Journal Article
Closed access
PDF file
CSC. W. P. Shi
C. W. P. Shi
XSXuechuan Shan
Xuechuan Shan
GTG. Tarapata
G. Tarapata
RJR. Jachowicz
R. Jachowicz
JWJerzy Weremczuk
Jerzy Weremczuk
HHH. T. Hui
H. T. Hui

1 August 2000 in Sensors and Actuators A: Physical
Verified
Journal Article
Closed access
RJR Jachowicz
R Jachowicz
JWJerzy Weremczuk
Jerzy Weremczuk

18 May 2022 in Sensors
Verified
Journal Article
Open access
PDF file
EKElżbieta Kałamajska
Elżbieta Kałamajska
Jacek MisiurewiczJacek Misiurewicz
Jacek Misiurewicz
JWJerzy Weremczuk
Jerzy Weremczuk
The purpose of this research was to develop an algorithm for a wearable device that would prevent people from drowning in swimming pools. The device should detect pre-drowning symptoms and alert the rescue staff. The proposed detection method is based on analyzing real-time data collected from a set of sensors, including a pulse oximeter. The pulse oximetry technique is used for measuring the heart rate and oxygen saturation in the subject’s blood. It is an optical method; subsequently, the measurements obtained this way are highly sensitive to interference from the subject’s motion. To eliminate noise caused by the subject’s movement, accelerometer data were used in the system. If the acceleration sensor does not detect movement, a biosensor is activated, and an analysis of selected physiological parameters is performed. Such a setup of the algorithm allows the device to distinguish situations in which the person rests and does not move from situations in which the examined person has lost consciousness and has begun to drown.

1 November 2006 in Sensors and Actuators A: Physical
Verified
Journal Article
Closed access
JWJerzy Weremczuk
Jerzy Weremczuk
GTG. Tarapata
G. Tarapata
DPD. Paczesny
D. Paczesny
RJR. Jachowicz
R. Jachowicz