Spatial interpolation methods are widely used in various fields and have been studied by several scholars with one or a few specific sampling datasets that do not reflect the complexity of the spatial characteristics and lead to conclusions that cannot be widely applied. In this paper, three factors that affect the accuracy of interpolation have been considered, i.e., sampling density, sampling mode, and sampling location. We studied the inverse distance weighted (IDW), regular spline (RS), and ordinary kriging (OK) interpolation methods using 162 DEM datasets considering six sampling densities, nine terrain complexities, and three sampling modes. The experimental results show that, in selective sampling and combined sampling, the maximum absolute errors of interpolation methods rapidly increase and the estimated values are overestimated. In regular-grid sampling, the RS method has the highest interpolation accuracy, and IDW has the lowest interpolation accuracy. However, in both selective and combined sampling, the accuracy of the IDW method is significantly improved and the RS method performs worse. The OK method does not significantly change between the three sampling modes. The following conclusion can be obtained from the above analysis: the combined sampling mode is recommended for sampling, and more sampling points should be added in the ridges, valleys, and other complex terrain. The IDW method should not be used in the regular-grid sampling mode, but it has good performance in the selective sampling mode and combined sampling mode. However, the RS method shows the opposite phenomenon. The sampling dataset should be analyzed before using the OK method, which can select suitable models based on the analysis results of the sampling dataset.
In this study, we evaluated estimates and predictions of the PM2.5 (fine particulate matter) concentrations and emissions in Xuzhou, China, using a coupled Lagrangian particle dispersion modeling system (FLEXPART-WRF). A Bayesian inversion method was used in FLEXPART-WRF to improve the emission calculation and mixing ratio estimation for PM2.5. We first examined the inversion modeling performance by comparing the model predictions with PM2.5 concentration observations from four stations in Xuzhou. The linear correlation analysis between the predicted PM2.5 concentrations and the observations shows that our inversion forecast system is much better than the system before calibration (with correlation coefficients of R = 0.639 vs. 0.459, respectively, and root mean square errors of RMSE = 7.407 vs. 9.805 µg/m3, respectively). We also estimated the monthly average emission flux in Xuzhou to be 4188.26 Mg/month, which is much higher (by ~10.12%) than the emission flux predicted by the multiscale emission inventory data (MEIC) (3803.5 Mg/month). In addition, the monthly average emission flux shows obvious seasonal variation, with the lowest PM2.5 flux in summer and the highest flux in winter. This pattern is mainly due to the additional heating fuels used in the cold season, resulting in many fine particulates in the atmosphere. Although the inversion and forecast results were improved to some extent, the inversion system can be improved further, e.g., by increasing the number of observation values and improving the accuracy of the a priori emission values. Further research and analysis are recommended to help improve the forecast precision of real-time PM2.5 concentrations and the corresponding monthly emission fluxes.
2 February 2019 in Environmental Science and Pollution Research