One of the urgent problems of mechanics is the study of the regularities of thermomechanical processes that affect the formation of microdefects in disloca
Mathematical models of the hydrodynamics and mass transfer processes during the mixed crystal growth from low-temperature aqueous solutions have been analyzed. The features of these processes are caused by complex design of the crystallizer with a shaper. Two models of the solution flowing into the shaper have been considered. In the first model, the solution is fed to the central part of the crystal. The second model presents a peripheral solution supply along the shaper perimeter, which allows us to create a swirling flow. The calculation models correspond to laminar and turbulent regimes of solution flow during the growth of K2(Co,Ni)(SO4)2•6H2O mixed crystal from an aqueous solution.
In this study, Ingots of (Bi, Sb)2Te3 thermoelectric material with p-type conductivity have been obtained by hot extrusion. The main regularities of hot extrusion of 30 mm rods have been analyzed with the aid of a mathematical simulation on the basis of the joint use of elastic-plastic body approximations. The phase composition, texture and microstructure of the (Bi, Sb)2Te3 solid solutions have been studied using X-ray diffraction and scanning electron microscopy. The thermoelectric properties have been studied using the Harman method. We show that extrusion through a 30 mm diameter die produces a homogeneous strain. The extruded specimens exhibit a fine-grained structure and a clear axial texture in which the cleavage planes are parallel to the extrusion axis. The quantity of defects in the grains of the (Bi, Sb)2Te3 thermoelectric material decreases with an increase in the extrusion rate. An increase in the extrusion temperature leads to a decrease in the Seebeck coefficient and an increase in the electrical conductivity. The specimens extruded at 450 °C and a 0.5 mm/min extrusion rate have the highest thermoelectric figure of merit (Z = 3.2 × 10−3 K−1).
Mathematical simulation results for inert gas (argon) dynamics in the rarefied atmosphere of Redmet-10 Cz single crystal silicon growth furnace chamber have been reported. Gas flows in cold (room temperature) and hot (growth process) chambers have been analyzed. Convective gas flows have been considered for two growth chamber gas supply options: basic supply, i.e., through the top central inlet hole only, and combined, i.e., with additional gas supply through the lateral inlet hole. Gas outlet is through the growth chamber bottom outlet hole for both options. For the cold chamber option, forced convection has been studied using the incompressible ideal gas model. For hot chamber, both the nonisothermal compressible ideal gas model and the weakly compressible gas model in the Boussinesq approximation have been used for studying the vortex structure produced by a joint action of forced and thermal-gravitational convection. The effect of different gas inlet methods on the convective transport of silicon monoxide evaporating from the free melt surface has been discussed.
We carry out an experimental-theoretical study of the process of the equal-channel angular pressing (ECAP) to obtain a bismuth-telluride-based thermoelectric (TE) material. A brief review of...
A detection of the conditions of high-rate single crystal growth with an appropriate quality is a priority for an industrial production of crystalline mate