Conventional mono-static defense radars have difficulty detecting low radar cross-section (L-RCS) targets, specifically small unmanned air vehicles (UAV) due to their radar cross-section and flight altitude. Passive bi-static radar (PBR) systems promise to improve the coverage of conventional surveillance radars by detecting and tracking the L-RCS targets. So far there are no experimental results in the literature for the detection of small UAVs using PBR. This paper presents for the first time the results of field trials for detecting a small UAV (average RCS) using a software defined multi-band multi-beam passive radar. Due to remoteness of the area of experiment the GSM signal of opportunity was generated using an own transmitter. The power of transmit signal was kept to 23dBm to have a realistic scenario.
Passive radar has been finding increasing application and use in last decade. Passive radar uses the "opportunistic" commercial signals for their operation. The passive radar does provide good Doppler resolution but suffer from bad range resolution. One way to improve the range resolution is to use passive radar in a multi-static fashion. By using the data collected at various multi-static sites, the range resolution can be improved. Therefore, there is a need for an algorithm for target localization using these multi-static measurements. Typically, these algorithms use range-only measurements. Various multi-static configurations are possible in passive radar setup. However, this paper will only consider the setup with single receiver, and multiple spatially distributed transmitter locations. Localization algorithm based on Maximum likelihood (ML) estimate will be presented, along with its efficient implementation using gradient and Newton's decent algorithms. The performance bounds for ML estimate in terms of Fisher information are also given. All the algorithms are verified using simulated data in 2D settings.
This paper can be divided into two main parts. In the first part, an extensive experimental study for electromagnetic characteristic assessment of different soil samples is presented. In the second part of the paper, a practical verification of the obtained link budget model is performed using a buried metal-backed RFID tag antenna under a 40 cm sand layer. This antenna is designed to operate at 915 MHz with MONZA3 chip. Using Impinj Speedway system the tag antenna could be detected, and its information could be read from different distances of up to more than 2.5 m.
1 January 2013 in Progress in Electromagnetics Research C