Signs and symptoms of temporomandibular joint (TMJ) dysfunction are commonly found in patients with facial asymmetry. Previous studies on the TMJ position have been limited to 2-dimensional (2D) radiographs, computed tomography (CT), or cone-beam computed tomography (CBCT). The purpose of this study was to compare the differences of TMJ position by using 2D CBCT and 3D model measurement methods. In addition, the differences of TMJ positions between patients with facial asymmetry and asymptomatic subjects were investigated. We prospectively recruited 5 patients (cases, mean age, 24.8 ± 2.9 years) diagnosed with facial asymmetry and 5 asymptomatic subjects (controls, mean age, 26 ± 1.2 years). The TMJ spaces, condylar and ramus angles were assessed by using 2D and 3D methods. The 3D models of mandible, maxilla, and teeth were reconstructed with the 3D image software. The variables in each group were assessed by t-test and the level of significance was 0.05. There was a significant difference in the horizontal condylar angle (HCA), coronal condylar angle (CCA), sagittal ramus angle (SRA), medial joint space (MJS), lateral joint space (LJS), superior joint space (SJS), and anterior joint space (AJS) measured in the 2D CBCT and in the 3D models (P < 0.05). The case group had significantly smaller SJS compared to the controls on both nondeviation side (P = 0.009) and deviation side (P = 0.004). In the case group, the nondeviation SRA was significantly larger than the deviation side (P = 0.009). There was no significant difference in the coronal condylar width (CCW) in either group. In addition, the anterior disc displacement (ADD) was more likely to occur on the deviated side in the case group. In conclusion, the 3D measurement method is more accurate and effective for clinicians to investigate the morphology of TMJ than the 2D method.

The aim of this study is to compare the differences in the stress distributions in the temporomandibular joints (TMJs) of the patients with facial asymmetry before and after bilateral sagittal split ramus osteotomy (BSSRO) under the symmetric occlusions using the three-dimensional (3D) finite element method. Ten facial asymmetry patients (Preoperative group, age 24.6 ± 4.8 years) and 10 asymptomatic subjects (Control group, age 26.8 ± 4.9 years) were recruited. After the patients underwent BSSRO, they were further assigned as the Postoperative group. 3D geometries of the finite element models of the mandible, disc, maxilla, and teeth were reconstructed according to cone-beam computed tomography (CBCT) image data. Contact elements were used to simulate the interaction of the disc-condyle, disc-temporal bone, and upper-lower dentition. The muscle forces and boundary conditions corresponding to the central and anterior occlusions were applied on the models of the 3 groups. The finite element models were validated with experimental data showing the accuracy of the simulation results. The simulation predicted preoperative significant differences of stresses between non-deviated sides and deviated sides were disappeared after the surgery under the central and anterior occlusions (P < .05). Almost all stresses in the patient models had significantly decreased after BSSRO, leveling it to the stress values of the normal subjects. Moreover, the simulation results coincided with the clinical cases which showed that BSSRO had helped to release or remove the signs and symptoms of temporomandibular disorders (TMD). In conclusion, BSSRO could correct the asymmetric stress distributions of TMJs and decrease the magnitude of the stresses for the patients with facial asymmetry. Those decreases also associated with the recovery of TMD.