In the process of metal purification, the study of controlling the morphology and size distribution of non-metallic inclusions in steel based on electric fields has attracted extensive attention. However, the action mechanism of electric fields on inclusions in liquid steel has not been clearly identified. In this paper, the influence of pulse current on the quantity, size, and distribution of alumina inclusions in liquid steel was explored through a high-temperature energization experiment, and the action mechanism of pulse current was expounded based on the angle of interface free energy. The results show that the number of small alumina inclusions in the steel after electric pulse treatment (the pulse current density was 0.1–3 A/cm², the frequency was 100 Hz, and the pulse waveform was a square wave) was significantly increased compared with the sample without electric pulse treatment, and the particle size was concentrated at 2–5 μm, and the inclusions were concentrated in the upper and lower parts of the sample. However, in the samples without electrification treatment, the large particles of inclusions are the majority, the particle size was concentrated at about 10 μm, and the inclusions were concentrated in the upper and middle parts of the samples. When the pulse current was applied to the molten steel, the interfacial free energy of the internal system of liquid steel alumina inclusion was reduced, the nucleation of alumina inclusion was promoted, the aggregation growth between alumina particles was inhibited, and then the migration and distribution of inclusions were also affected. The experimental results could provide technical support for high-quality steel smelting production to a certain extent.

High manganese steel can improve its microstructure after aging treatment, which is beneficial for enhancing strength, toughness, and wear resistance. This study aims to explore the effect of aging treatment on mechanical properties and wear resistance of high manganese steel (containing 25% Mn, called Mn25 steel) by designing different aging temperatures (450 °C, 500 °C, and 550 °C) with the same aging time (1 h). The results indicated that with the increase in aging treatment temperature, the surface hardness of Mn25 steel first increased and then decreased, but was still higher than that of untreated Mn25 steel. In addition, the impact toughness of steel decreased first and then increased with the increase in aging temperature, with the optimal hardness and impact toughness exhibited at 550 °C. The impact abrasive wear test results showed that the weight loss of Mn25 steel decreased with the increase in aging treatment temperature. After aging treatment at 550 °C, the weight loss is the lowest, which shows the optimal wear resistance performance. Under a high-impact load of 5.0 J, the hardness increased by nearly 49.96% after impact abrasive wear, and the effective hardening layer of the steel was the thickest, about 3800 μm. This is mainly related to the best match between the hardness and impact toughness of high manganese steel after aging treatment. The wear morphology is often caused by various wear mechanisms working together to cause the wear loss of Mn25 steel during the impact wear process. The wear morphologies of the Mn25 steel were mainly characterized by press-in particles, furrow, spalling, and strain fatigue. Through experimental analysis, a suitable aging treatment process has been determined, providing a theoretical basis for the practical application of high manganese steel.