Soil stabilization, through either physical or chemical techniques of coating-cementation development, is a commonly adopted practice in geotechnical and transportation engineering projects used to strengthen soils and mitigate negative geo-environmental impacts. This can be particularly important in enhancing the mechanical properties of soils which are prone to degradation of their response because of freezing and thawing actions. It was attempted in this research study to examine the effect of lime–zeolite stabilization on the behavior of a silt-sized natural soil of low plasticity, by performing standard compaction tests as well as unconfined compressive experiments evaluating the strength of the composite samples. The natural soil mixed with various contents of lime and zeolite partial replacement was subjected to consecutive freezing and thawing cycles. The results from the study showed significant improvement of the mechanical performance of the treated soil when mixed with lime partially replaced with zeolite in terms of strength and durability and, based on scanning electron microscopic images, additional insights were attempted to be obtained on the microstructure of the specimens subjected to temperature changes.
1 June 2009 in Construction and Building Materials
This paper presents the investigation of the effect of pavement surface temperature on the frictional properties of the pavement–tyre interface. Many skid tests were carried out on different wearing surfaces and under different climatic conditions using both ribbed and smooth tyres over 15 months. The pavement and air temperatures were obtained in each test using thermocouples located directly under the wearing course and close to the pavement surface, respectively. Regression analyses were carried out to determine the effect of pavement temperature on the measured skid number at different speeds, along with friction model parameters. The main conclusion of this investigation demonstrates that the pavement temperature has a significant effect on pavement frictional measurements and on the sensitivity of the measurements to the test speed. Both the skid number at zero speed (SN0) and the per cent normalised gradient tend to decrease with increased pavement temperature. At low speed, pavement friction tends to decrease with increased pavement temperature, and at high speed, the effect is reverted and pavement friction tends to increase with increasing pavement temperature. Temperature-dependent friction vs. speed models were developed for one of the mixes studied. These models could be used to define temperature correction factors.
25 May 2020 in Geotechnical and Geological Engineering