The turbulent pulsating flow and heat transfer in straight and 90° curved square pipes are investigated in this study. Both experimental temperature field measurements at the cross-sections of the pipes and conjugate heat transfer (CHT) simulation were performed. The steady turbulent flow was investigated and compared to the pulsating flow under the same time-averaged Reynolds number. The time-averaged Reynolds number of the pulsating flow, as well as the steady flow, was approximately 60,000. The Womersley number of the pulsating flow was 43.1, corresponding to a 30 Hz pulsating frequency. Meanwhile, the Dean number in the curved pipe was approximately 31,000. The results showed that the local heat flux of the pulsating flow was greater than that of the steady flow when the location was closer to the upstream pulsation generator. However, the total heat flux of the pulsating flow was less than that of the steady flow. Moreover, the instantaneous velocity and temperature fields of the simulation were used to demonstrate the heat transfer mechanism of the pulsating flow. The behaviors, such as the obvious separation between the air and pipe wall, the low-temperature core impingement, and the reverse flow, suppress the heat transfer.

This paper discusses the turbulent flow and heat transfer from a uniform air flow with high temperature to the outside through a 90° curved square pipe. Both conjugate heat transfer (CHT) simulation and experiments of temperature field measurements at cross sections of the pipe are performed. A straight pipe is investigated and compared with the 90° curved pipe. The temperature of the air flow at the inlet of the pipe is set at 402 K, and the corresponding Reynolds number is approximately 6 × 10⁴. To obtain the spatial average temperature at each cross section, the temperature fields are measured along the streamwise of the pipes and in the circumferential direction using thermocouples at each cross section from the inlet to the outlet of both the straight and curved pipes. Furthermore, the simulation is performed for turbulent flow and heat transfer inside the pipe wall using the Re-normalization group (RNG) k-ε turbulence model and CHT method. Both the experimental and numerical results show that the curvature of the pipe result in a deviation and impingement in the high-temperature core and a separation between the wall and air, resulting in a secondary flow pattern of the temperature distribution.