Ondřej Mašek

Ondřej Mašek


Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2020 in Water Research
Verified
Journal Article
Closed access
MZMing Zhang
Ming Zhang
GSGe Song
Ge Song
DGDanielle Gelardi
Danielle Gelardi
LHLongbin Huang
Longbin Huang
EKEakalak Khan
Eakalak Khan
YOYong Sik Ok
Yong Sik Ok

21 December 2012 in GCB Bioenergy
Verified
Journal Article
Open access
PDF file
KCKyle Crombie
Kyle Crombie
OMOndřej Mašek
Ondřej Mašek
Saran SohiSaran Sohi
Saran Sohi
PBPeter Brownsort
Peter Brownsort
ACAndrew Cross
Andrew Cross
Biochar is the porous, carbonaceous material produced by thermochemical treatment of organic materials in an oxygen‐limited environment. In general, most biochar can be considered resistant to chemical and biological decomposition, and therefore suitable for carbon (C) sequestration. However, to assess the C sequestration potential of different types of biochar, a reliable determination of their stability is needed. Several techniques for assessing biochar stability have been proposed, e.g. proximate analysis, oxygen (O): C ratio and hydrogen (H): C ratio; however, none of them are yet widely recognized nor validated for this purpose. Biochar produced from three feedstocks (Pine, Rice husk and Wheat straw) at four temperatures (350, 450, 550 and 650 °C) and two heating rates (5 and 100 °C min−1) was analysed using three methods of stability determination: proximate analysis, ultimate analysis and a new analytical tool developed at the UK Biochar Research Centre known as the Edinburgh accelerated ageing tool (Edinburgh stability tool). As expected, increased pyrolysis temperatures resulted in higher fractions of stable C and total C due to an increased release of volatiles. Data from the Edinburgh stability tool were compared with those obtained by the other methods, i.e. fixed C, volatile matter, O : C and H : C ratios, to investigate potential relationships between them. Results of this comparison showed that there was a strong correlation (R > 0.79) between the stable C determined by the Edinburgh stability tool and fixed C, volatile matter and O : C, however, H : C showed a weaker correlation (R = 0.65). An understanding of the influence of feedstock and production conditions on the long‐term stability of biochar is pivotal for its function as a C mitigation measure, as production and use of unstable biochar would result in a relatively rapid return of C into the atmosphere, thus potentially intensifying climate change rather than alleviating it.

1 July 2013 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
LZLing Zhao
Ling Zhao
XCXinde Cao
Xinde Cao
OMOndřej Mašek
Ondřej Mašek
AZAndrew Zimmerman
Andrew Zimmerman

1 February 2009 in Energy Procedia
Verified
Journal Article
Open access
ABAdina Bosoaga
Adina Bosoaga
OMOndřej Mašek
Ondřej Mašek
JOJohn E. Oakey
John E. Oakey
The effect of the increasing concentration of CO2 in the atmosphere on climate change is a major driving force for the development of advanced energy cycles incorporating CO2 management options. Growing interest in the technical and economic feasibility of CO2 capture from large coal-based power plants has led to increased efforts worldwide to develop new concepts for greater CO2 reductions in the future. Greenhouse gas emissions, especially CO2, have to be reduced by 50–80% by 2050, according to the IPCC [1].The type of fuel used in cement manufacture directly impacts on CO2 emissions, with coal accounting for around 60–70% of CO2 emissions from cement installations. Therefore, the large amount of carbon dioxide emitted during cement manufacturing process - 5% of the total emissions of CO2 from stationary sources worldwide - is a cause of great concern and has to be tack led in order to comply with current legislation.Several technologies are available and have been proposed for the separation of CO2 from the flue gases from new and existing plants with retrofit capture units. Few studies have been undertaken on CO2 capture in cement plants to assess the suitable technologies, with oxy-combustion and amine scrubbing as the possible options (pre-combustion capture not being viable). This paper summarises the different CO2 capture technologies suitable for cement industry and assesses the potential of the calcium looping cycle [2,3] as a new route for CO2 capture in the cement industry. The potential advantage of this system is the very low efficiency penalty expected (<6%) compared with other capture technologies as the heat required for calcination is balanced by heat released during the carbonation (CO2 capture) step and can be utilized efficiently at high temperature in the plant’s steam cycle. Since limestone is already used for cement manufacture, and because it is a cheap material with good geographical distribution, it allows the use of local limestone resources with minimal limestone-related infrastructure investment. Another envisaged benefit of this new technology is that the lime purged from the cycle could be us ed as a raw material for the production of cement clinker. Therefore, the calcium looping cycle can potentially have an important impact in reducing CO2 emissions from the cement industry, and may also be applicable in other sectors

1 January 2013 in Fuel
Verified
Journal Article
Closed access
OMOndřej Mašek
Ondřej Mašek
PBPeter Brownsort
Peter Brownsort
ACAndrew Cross
Andrew Cross
Saran SohiSaran Sohi
Saran Sohi

1 October 2020 in Renewable and Sustainable Energy Reviews
Verified
Journal Article
Closed access
MCMarco Chiappero
Marco Chiappero
ONOmid Norouzi
Omid Norouzi
MHMingyu Hu
Mingyu Hu
FDFrancesca Demichelis
Francesca Demichelis
Franco BerrutiFranco Berruti
Franco Berruti
SFSilvia Fiore
Silvia Fiore