Subboiling distillation has been used since two decades for the purification of analytical grade acids from inorganic contaminants and demonstrated an efficient method to obtain pure acids starting from reagent grade chemicals. Nevertheless, the effect of the subboiling parameters on the purity of the distilled acids has never been methodically investigated. Aim of the present research is a systematic evaluation of the subboiling distillation protocol for the production of pure hydrochloric and nitric acid. In particular, the effect of the subboiling temperature and the number of subsequent distillations was investigated as these parameters were recognised as the most important factors controlling acid purity, acid concentration, and distillation yield. The concentration of twenty elements in the purified acids was determined by Inductively Coupled Plasma-Mass Spectrometry. As a result, the subboiling temperature (up to 82°C) and the number of subsequent distillations (up to four) were demonstrated not to affect the purity of the distilled nitric and hydrochloric acids. Under normal laboratory conditions, the residual elemental concentrations were in most cases below 10 ng/L in both nitric (2.75% w/w) and hydrochloric (0.1 M) blanks. Ultrapure nitric and hydrochloric acids could accordingly be produced under the most favorable conditions, i.e., the highest temperature and one distillation process only.
Biochar nanoparticles (BC NPs), produced by low temperature pyrolysis (350 °C) of microalgae (Nannochloropsis sp.) and nutshells, are proposed as low-cost and sustainable co-catalysts to promote the photocatalytic activity of TiO2 nanotube (NT) arrays towards the degradation of methylene blue (MB) used as an organic pollutant model molecule. BC NPs (size < 25 nm) were obtained by treating bulk BC (i.e., biomass after pyrolysis) by sonication–centrifugation cycles in a water solution. The filtered BC NPs dispersion was deposited by simple drop-casting on the TiO2 NT support. The BC loading was varied by performing multiple depositions. Photocatalytic experiments under UV light (365 nm) revealed that the decoration with BC NPs significantly improves the TiO2 photoactivity. Such enhancement is mainly influenced by the amount of BC deposited; upon optimizing the BC deposition conditions, the rate of photocatalytic degradation of MB increases approximately three times with respect to bare TiO2, almost irrespective of the nature of the raw material. The greater photocatalytic activity of BC-TiO2 can be attributed to the synergistic combination of reactant/product adsorption and catalytic degradation of the adsorbed organic pollutant, as well as an improved charge carrier separation and electron transfer.