We constructed an active imaging model within 10 km of the atmosphere from the satellite to the ground based on Monte Carlo (MC) algorithm, and, because of the inhomogeneous distributions of the scattering particles in atmosphere environment, 10 km atmosphere layer was divided into ten layers in our model. The MC algorithm was used to simulate the transmission process of photons through the atmosphere. By launching lasers of linear polarization states from satellites to ground, the intensity, degree of polarization (DoP), polarization difference (PD), and polarization retrieve (PR) images can be obtained. The contrast of the image, peak signal to noise ratio (PSNR), and structural similarity index (SSI) were used to evaluate the imaging quality. The simulated results demonstrate that the contrast of images is degraded as the atmosphere becomes worse. However, PR imaging have a better contrast and better visibility in different atmospheric conditions. Meanwhile, we found that Mueller matrix (MM) can retrieve the original images very well in a certain range of atmospheric conditions. Finally, the simulation also shows that different wavelengths of light sources have different penetration characteristics, and, in general, infrared light shows better performances than visible light for imaging.
5 April 2022 in IEEE Transactions on Geoscience and Remote Sensing
The existing scattering medium has a serious impact on the optical remote sensing. It is a challenge and urgent problem to extract the original target’s information influenced by scattering systems. Here, we adopt the target’s polarization information as the original data and load it into the modified U-net-based deep-learning network (MU-DLN) to retrieve the original target’s information influenced by the scattering medium. The dense blocks in the MU-DLN can extract the features of the target information contained in the polarization images. Meanwhile, the peak signal-to-noise ratio (PSNR) and structural similarity index (SSIM) have been used to evaluate the quality of target reconstruction. The experimental results show that our strategy can reconstruct the target’s information very well, and the model trained for a fixed optical thickness (OT) environment can also be used for remote sensing in the larger or smaller OT environment within a certain range. In addition, due to the polarization imaging characteristics, compared with traditional methods, our strategy can improve the quality of target reconstruction effectively. Our work provides a new direction for DL technique in remote sensing of targets’ information from the complex scattering systems.
In this paper, we investigated depolarization performance of polarized light in fog scattering system using the indices of polarimetric purity (IPPs) based on the Monte Carlo (MC) algorithm. We compared and analyzed the performances of degree of polarization (DoP) and IPPs in mono-disperse and poly-disperse scattering systems. The depolarization performance of mono-disperse scattering system is dependent on incident infrared wavelength. For the poly-disperse scattering system, the depolarization performance is significantly dependent on the particle-size distributions and the proportion of small particles. These results demonstrate that the IPPs can describe the depolarization performances of disperse systems effectively. It is of great practical significance because it can transmit information in high fidelity better than the DoP.
Computational ghost imaging (CGI) can reconstruct scene images by two-order correlation between sampling patterns and detected intensities from a bucket detector. By increasing the sampling rates (SRs), imaging quality of CGI can be improved, but it will result in an increasing imaging time. Herein, in order to achieve high-quality CGI under an insufficient SR, we propose two types of novel sampling methods for CGI, to the best of our knowledge, cyclic sinusoidal-pattern-based CGI (CSP-CGI) and half-cyclic sinusoidal-pattern-based CGI (HCSP-CGI), in which CSP-CGI is realized by optimizing the ordered sinusoidal patterns through “cyclic sampling patterns,” and HCSP-CGI just uses half of the sinusoidal pattern types of CSP-CGI. Target information mainly exists in the low-frequency region, and high-quality target scenes can be recovered even at an extreme SR of 5%. The proposed methods can significantly reduce the sampling number and real-time ghost imaging possible. The experiments demonstrate the superiority of our method over state-of-the-art methods both qualitatively and quantitatively.
The high-accuracy optical detection of oceanic targets is significantly important but challenging due to the complex conditions around the sea surface, where water droplets and bubbles often interfere with optical signals. These interferences affect both the intensity and direction of the optical signals, making target identification difficult. To address this issue, we propose a theoretical model based on photon tracing to explore the polarization characteristics of oceanic targets in scattering environments. This model tracks the evolution of the State of Polarization (SoP) of photons interacting with droplets and bubbles. Utilizing the Monte Carlo algorithm, our model simulates a large number of photon interactions, taking into account the parameters such as the number density, size distribution of water droplets and bubbles, and the initial polarization state of incident light. Meanwhile, our simulation assumes a homogeneous scattering medium and isotropic scattering properties for computational efficiency. The multidimensional polarization information, combined with Upper-hemisphere-space Polarization Data (UPD), enhances the identification and analysis of oceanic targets. Our results show distinct disparities in UPD for sea scenarios with and without targets, demonstrating the significant potential of our approach for oceanic target detection and polarization sensing.