Bio-based semicrystalline polylactide (PLA) has a growing value as a substitute for fossil-based polyesters in technical applications and as a biocompatible material in medicine. The complexity of the behavior of PLA, determined by the presence of different stereoisomers, the role of electrostatic interactions, and its slow crystallization rate, makes computer simulations an important tool to discover new approaches to control the properties of PLA-based materials. The goal of this review is to summarize the efforts to simulate PLA materials with different levels of detail, including the quantum mechanical approach, all-atom modeling, and coarse-grained particle models. We focus on the validation of the models and the ways to cross-check the results with other simulation and experimental data. Special attention is devoted to the simulations of PLA in the presence of water, which provide insights into molecular mechanisms of hydrolytic degradation of PLA, especially at the initial stage, when the structural changes can not yet be detected by experimental methods. Ultimately, the selection of the appropriate simulation methods can facilitate material design, by combining the throughput and level of detail necessary for the job.
The phase diagram of helix–coil diblock copolymers was built via molecular dynamics simulation. Special morphologies such as cylinders with elliptical cross-sections on a distorted lattice and lamellae with strict helical packing were characterized.
The Monte Carlo method is used to study macromolecule layers with mobile grafting points during deterioration in the solvent quality. If the chains are rigidly grafted onto the surface, the micelle core is bonded to the surface through chain fragments that are strongly extended along the surface, but if the points are fairly mobile, the micelles are dense aggregates maximally segregated from the surface. In addition, an increase in the mobility of the chains leads to increase in the mean aggregation number of the micelles, its dispersion, and height of the aggregate.
12 August 2024 in Molecular Systems Design & Engineering
Bulk radical copolymerisation of N-vinylcaprolactam (VCL) and N-vinylimidazole (VI) is studied experimentally and theoretically. It is shown that the copolymer composition is maintained up to high comonomer conversions. This is explained by a constant ratio of concentrations of comonomers in the reaction zone. The copolymers obtained show thermally induced conformational behaviour. In an aqueous medium above 60 °C, they can form compact globular structures with a hydrophobic core of VCL monomer units covered by a hydrophilic corona of VI monomer units, which allows them to be considered as a basis for thermally switchable functional nanostructures.
The bulk radical copolymerization of N-vinylcaprolactam (VCL) and N-vinylimidazole (VI) initiated by 2,2′-azobisisobutyronitrile (AIBN) was investigated. The composition of the resulting amphiphilic copolymers is always enriched in VI units and is independent of the initiator concentration in the range from 0.001 to 0.1 mol L−1. The reactivity ratios calculated at an AIBN concentration of 0.005 mol L−1 (rVI = 5.33 ± 0.58 and rVCL = 0.21 ± 0.01) are practically identical to those previously obtained at 0.01 mol L−1. The independence of the copolymer composition from the initiator concentration is due to the self-assembly of amphiphilic macromolecules formed during copolymerization.