Biological treatment, composting, in particular, is a relatively simple, durable and inexpensive alternative for stabilizing and reducing biodegradable waste. Co-composting of different waste sources allows to enhance the compost nutrient value. In particular, integration of ‘biosolids’ from the sanitation sector as potential input material for co-composting would provide a solution for the much needed treatment of fecal sludge from on-site sanitation systems, and make use of its high nutrient content. This research paper elaborates in detail the main parameters that govern the co-composting process as well as factors that control the production of a safe and valuable quality compost. It further explains technological options to tailor the final product to crop and farmer needs
This paper describes a study that was aimed at optimizing the pelletization of fecal sludge-based fertilizers for agricultural use. The process developed is easy to implement and increases the marketability of the products while also addressing a serious health and environmental challenge. The study took place during the period 2011-2012 in Ghana. The fecal sludge, rich in nutrients and organic matter, was dried and used to produce five different fertilizers (i.e., four formulations of compost and one with gamma irradiated material). Each material was then pelletized using locally constructed machinery. Key operating parameters, such as moisture content (10-55% in mass), binder type (clay or starch) and concentration (0-10% in mass), were varied and their impacts on the characteristics of pellets (e.g., amount of fine materials generated, length distribution or stability of pellets, and pellet disintegration rate) were also followed. Given the low analyzing capabilities of developing countries, some simple analytical methods were developed and used to compare pellets produced under different conditions. The results confirmed that the addition of 3% of pregelatinized starch is recommended during pelletization of fecal sludge-based fertilizers. Applicable moisture contents were also identified per fertilizer type, and were found to comprise between 21 and 43%.
Lignite amendment of livestock manure is considered a viable ammonia (NH3) emission mitigation technique. However, its impact on the subsequent composting of the manure has not been well studied. This work compared changes in biochemical parameters (e.g., organic matter loss and nitrogen (N) transformation) and also the emissions of NH3 and greenhouse gases (GHGs) between lignite-amended and unamended cattle manure during forced aeration composting. Amending manure with lignite did not alter the time to compost stability despite delaying the onset of the thermophilic temperatures. Lignite treatments retained N in the manure by suppressing NH3 loss by 35–54%, resulting in lignite-amended manure composts having 10–19% more total N than the unamended compost. Relative to manure only, lignites reduced GHG emissions over the composting period: nitrous oxide (N2O) (58–72%), carbon dioxide (CO2) (12–23%) and methane (CH4) (52–59%). Low levels of CH4 and N2O emissions were observed and this was attributed to the continuous forced aeration system used in the composting. Lignite addition also improved the germination index of the final compost: 90–113% compared to 71% for manure only. These findings suggest that lignite amendment of manure has the potential to improve the quality of the final compost whilst mitigating the environmental release of NH3 and GHGs.