Proceeding to 21st CIRP Conference on Life Cycle EngineeringManufacturing, where great amount of energy and materials are being consumed, should take response to have cleaner production and to improve its sustainability. Additive manufacturing (AM) technology shows potential to reduce environment impact as a more sustainable manufacturing method; however, the lack of well documented energy consumption and material flow data limits the development of Life-Cycle Inventory (LCI) analysis of AM technology. This paper presents an energy and material consumption model of Binder-Jetting (BJ) process. A Unit-Process (UP) level model is created and validated by experimental data to provide LCI data for further Life-Cycle Analysis (LCA) of BJ additive manufacturing processes. The accurate process model provides a tool to industry to understand the energy consumption and material efficiency aspect of the binder-jetting process and to allow comparisons with traditional processes. Keywords:EcoSD networ

Purpose – To discuss integration of the rapid prototyping environmental aspects with the primary focus on electrical energy consumption. Design/methodology/approach – Various manufacturing parameters have been tested on three rapid prototyping systems: Thermojet (3DS), FDM 3000 (Stratasys) and EOSINT M250 Xtended (EOS). The objective is to select sets of parameters for reduction of electrical energy consumption. For this, a part is manufactured in several orientations and positions in the chamber of these RP systems. For each test, the electrical power is noted. Finally, certain rules are proposed to minimize this electrical energy consumption during a job. Findings – It is important to minimize the manufacturing time but there is no general rule for optimization of electrical energy consumption. Each RP system must be tested with energy consumption considerations under the spotlight. Research limitations/implications – The work is only based on rapid prototyping processes. The objective is to take into consideration the complete life-cycle of a rapid prototyped part: manufacturing of raw material as far as reprocessing of waste. Practical implications – Reduction of electrical energy consumption to complete a job. Originality/value – Currently, environmental aspects are not well studied in rapid prototyping.

Considering the potential for new product design possibilities and the reduction of environmental impacts, Additive Manufacturing (AM) processes are considered to possess significant advantages for automotive, aerospace and medical equipment industries. One of the commercial AM techniques is Binder-Jetting (BJ). This technique can be used to process a variety of materials including stainless steel, ceramic, polymer and glass. However, there is very limited research about this AM technology on sustainability aspect. This paper presents a method to build an energy consumption model for printing stage of BJ process. Mathematical analyses are performed to find out the correlation between the energy consumption and geometry of the manufactured part. Based on the analyses, total energy consumption is calculated as a function of part geometry and printing parameters. Finally, test printing is performed to check the accuracy of the model. This process model provides a tool to optimize part geometry design with respect to energy consumption

In the context of a circular economy, one can observe that (i) recycling chains are not adapted enough to the end-of-life products they have to process and that (ii) products are not sufficiently well designed either to integrate at best their target recycling chain. Therefore, a synergy between product designers and recycling-chains stakeholders is lacking, mainly due to their weak communication and the time-lag between the product design phase and its end-of-life treatment. Many Design for Recycling approaches coexist in the literature. However, to fully develop a circular economy, Design from Recycling also has to be taken into account. Thus Re-Cycling, a complete circular design approach, is proposed. First, a design for recycling methodology linking recyclability assessment to product design guidelines is proposed. Then, a design from recycling methodology is developed to assess the convenience of using secondary raw materials in the design phase. The recyclability of a smartphone and the convenience of using recycled materials in a new cycle are both analyzed to demonstrate our proposal. The Fairphone 2^® and its treatment by the WEEE French takeback scheme are used as a case study.