The aim of this paper is to investigate the effect of different burnishing strategy on a C45 steel machining. Burnishing is a well-known, cold working surface improving technology, it is usually applied for cylindrical workpiece. In the reported research a novel developed magnetic assisted ball burnishing (MABB) tool was applied which was designed for MABB machining of flat and harmonic surfaces. To increase its efficiency, different types of machining strategies were applied. After the burnishing process the machined surfaces were measured by surface roughness tester to determine the most important Rsk and Rku tribological parameters. According to the results it can be stated that all different burnishing strategies have special application areas where they can be used efficiently (e.g. sliding surface, moulding tool and after-or pre-machining for ultra-precision machining).

The 1.4306 austenite stainless steel has been prominently utilized as a material in the automotive and aerospace industry. Considerable interest has been garnered in the machinability of stainless steel owing to its high strength and poor thermal conductivity. The aim of this study is to ascertain the influential cutting parameters, specifically the cutting speed and feed rate, on cut-ting forces, cutting temperature, and chip evaluation. Thus, austenite stainless steel was subjected to free-cutting using a carbide recessing tool under dry conditions. The principle of measuring cutting temperature, a complex procedure due to varying thermal homogeneity, was elucidated. For the turning experiments in question, the standard Taguchi orthogonal array L9 (3²), featuring two factors and three levels, was employed. The experimental results were analyzed using MiniTab 17 software. The findings reveal a substantial effect of feed rate on cutting force, cutting temperature, and chip evaluation. The highest cutting force and cutting temperature were observed at a feed rate of 0.15 mm/rev. Conversely, the cutting force was minimized at a cutting speed of 100 m/min, indicating potential for increasing the cutting speed. The augmentation of feed rate led to chip compression and discoloration, attributed to elevated cutting force and a larger chip cross-section that efficiently dissipates heat from the cutting zone.

Nickel-based superalloys are among the most difficult materials to machine because they have high thermal strength, they are prone to hardening, carbides severely abrade the tool, and they have very poor thermal conductivity. Slot milling is a specific issue as it is characterized by rapid tool wear and frequent tool breakages. This is why reconditioned tools are frequently employed in industrial environments, as they can considerably decrease the expenses associated with tools. The chosen machining strategy also plays a crucial role in the tool’s lifespan and the quality of the machined surface, making it essential to select the appropriate strategy. Hence, the authors have opted for two conventional trochoidal strategies, namely the circular and swinging toolpath, along with a contemporary toolpath known as the Autodesk Inventor HSM Adaptive strategy. The authors investigated the effects of technological parameters and toolpaths on cutting forces, tool wear, surface roughness and burr formation on machined edges. The results show that lower cutting parameters and adaptive strategies lead to the smallest tool loads, tool wear, the best quality of surface roughness and burr formation on machined edges.