Experimental studies of both drainage and imbibition displacements are needed to improve our fundamental understanding of multi-phase flow and trapping in CO2-brine systems and effectively take advantage of the large storage capacity of saline aquifers. Very few relative permeability measurements have been made and even fewer with in situ saturation measurements. Two new sets of steady state relative permeability measurements have been made in two different rock samples, and over a range of injection flow rates. These studies show that multi-phase brine displacement efficiency is strongly affected by the heterogeneity of the core. Moreover, we observe that, at any given fractional flow, different flow rates result in different CO2 saturations. Similarly, different flow rates lead to different relative permeability curves. Numerical simulations of two phase displacement are performed on one sample, and at one fractional flow of CO2. Numerical simulations demonstrate that some of the features of the saturation distributions can be qualitatively replicated. However, improvements in the correlations between porosity, saturation and capillary pressure will be needed to replicate the saturation distributions measured in the experiments
Summary: This paper presents an approximate semianalytical solution for predicting the average steady-state saturation during multiphase coreflood experiments across a wide range of capillary and gravity numbers. Recently, the influences of flow rate, gravity, and subcore heterogeneity on brine displacement efficiency have been studied with the 3D simulator TOUGH2 (Kuo et al. 2010). These studies have demonstrated that the average saturation depends on the capillary and gravity numbers in a predictable way. The purpose of this paper is to provide a simple and approximate semianalytical solution for predicting the average saturation (during two-phase coreflood experiments across a wide range of flow rates) for different average rock properties and fluid pairs. A 2D analysis of the governing equations for the multiphase-flow system at steady state is used to develop the approximate semianalytical solution. We have developed a new criterion to identify the viscous-dominated regime at the core scale. Variations of interfacial tension (IFT), core permeability, and length of the core and the effects of buoyancy, capillary, and viscous forces are all accounted for in the semianalytical solutions. We also have shown that three dimensionless numbers (NB, Ngv, Rl) and two critical gravity numbers (Ngv,c1, Ngv,c2) are required to properly capture the balance of viscous, gravity, and capillary forces. There is good agreement between the average saturations calculated from the 3D simulations and the analytical model. This new model can be used to design and interpret multiphase-flow coreflood experiments, gain better understanding of multiphase-flow displacement efficiency across a wide range of conditions and for different fluid pairs, and perhaps even provide a tool for studying the influence of subgrid-scale multiphase-flow phenomena on reservoir-scale simulations.
Carbon dioxide capture and sequestration in saline aquifers is considered one of the most important technologies for short and medium term climate change mitigation. There are many challenges for wide scale deployment of sequestration, including developing a sufficiently accurate fundamental understanding of the processes which govern the movement of supercritical CO2 in saline aquifers. A method for testing our understanding of the underlying physics is to conduct numerical simulations intended to replicate a multiphase flow experiment in which CO2 is injected into a brine saturated rock core. This paper focuses on methods to integrate pore scale rock properties into permeability models of cores subjected to such experiments. We use thin sections to measure pore scale features of rocks, and test correlations that relate permeability to porosity using the Carman–Kozeny equation. Incorporation of these pore scale features into sub-core scale maps of permeability is being used to history match core-scale multi-phase flow experiments
International audienceA series of steady state core-scale multiphase flow experiments at a wide range of fractional flows of CO 2 (95%, 79%, 61%, 34%, 26%) and different total flow rates have been simulated by using TOUGH2 MP with ECO2N simulator. CO 2 and brine were co-injected into the brine saturated core at reservoir conditions (P=12.4MPa and T=50˚C), average carbon dioxide saturations and sliced average saturation along the core were measured after steady state. Moreover, carbon dioxide saturation distributions can also be observed in the simulations to study the heterogeneous effect on displacement efficiency. To investigate the heterogeneity and gravity effect on brine displacement efficiency, 95% fractional flow of CO 2 and 5% brine were injecting into homogeneous and heterogeneous cores in the absence of gravity and including gravity at specific flow rates. When injection rates are large enough (viscous-dominated regime) and low enough (capillary-dominated regime), gravity effect can be neglected. These high resolution simulations can help us to understand the interplay of three physical forces on brine displacement efficiency