Many factors, such as climate change and the associated risk of increasing the average temperature on the globe, energy security and the finishing of fossil fuel deposits have caused other renewable energy sources to be sought. Transport, as a branch of industry largely responsible for air pollution and greenhouse gas emissions in large cities, requires the necessary changes in the way vehicles are powered. Until now, the fuels available at petrol stations use admixtures of first generation biofuels, such as bioethanol, as a 5% additive to motor gasolines and biodiesel (FAME) as a 7% additive to diesel oil. The article presents the idea of biorefinery installations, specifies the spectrum of substrates of the second and advanced generations, which may be a biorefinery input, including waste oils that can be used to produce hydrogenated HVO vegetable oils and other high-value products. The paper presents he existing biorefinery plant in Venice resulting from the transformation of a conventional oil refinery in which HVO fuel is produced. The article also presents the parameters of this new biofuel and compared them with the parameters of other fuels used to power self-ignition engines, such as FAME and diesel, along with discussing the prospects for HVO fuel development in Europe.

Biorefinery Systems as an Element of Sustainable Development | InTechOpen, Published on: 2015-09-30. Authors: Krzysztof Biernat and Paulina Luiza Grzelak

Vehicles equipped with an LPG retrofit system are always started on gasoline. Therefore, part of the vehicle's annual mileage will be run on gasoline. This article describes the results of tests conducted on a vehicle equipped with a propane-butane gas retrofit system (LPG system) regarding gasoline consumption in the LPG mode depending on the temperature at which the engine is started. The research was carried out on a passenger car from the C segment with an engine with indirect gasoline injection system. Based on these studies, the analysis of various vehicle use scenarios and the related gasoline consumption in relation to LPG consumption was made.

This article presents the properties of EtG synthetic fuel (Ethanol to Gasoline) as a substitute for fuels in an installation using ethanol from food waste as a raw material. The results of this research on the process of supplying the engine with EtG fuel are presented, in which the operational suitability of this fuel was verified, including environmental requirements. The results of pollutant emission tests from vehicles with spark-ignition engines in dynamic driving conditions in the New European Driving Cycle (NEDC) type approval tests and the World Harmonized Test Cycle (WLTC) test, both on a “cold” and “hot engine”, are presented. It was found that EtG fuel is characterized by lower emissions of carbon monoxide, nitrogen oxides, and methane, and higher emissions of non-methane hydrocarbons compared to E10 commercial gasoline, while the specific distance emission of carbon dioxide for both fuels was very similar.

The methodologies for calculating exhaust emissions and fuel consumption, which are given in the normative documents, do not take into account the fact that vehicles equipped with liquefied petroleum gas (LPG) or compressed natural gas (CNG) systems are fueled with petrol after a cold start. When calculating exhaust emissions and fuel consumption of LPG or CNG-powered vehicles, it is assumed that they result from the combustion of gaseous fuel only. This simplification leads to an incorrect determination of the emissions and fuel consumption values, as the formulas for calculating these values differ depending on the fuel type. This article presents the results of tests aimed at checking how that factor affects the value of emissions and fuel consumption calculated in the driving cycles used in the type-approval tests. In order to estimate the error resulting from this simplification, the tests of exhaust emissions and fuel consumption of a vehicle equipped with an LPG system were carried out. The tests were carried out on a chassis dynamometer in the worldwide harmonized light vehicles test cycle (WLTC) used in the type approval tests. In the tested vehicle, the CO, total hydrocarbons (THC), NO_x and CO₂ emissions calculated with the normative method were approx. 7% lower than the values calculated with the corrected method. For this reason, there is a need to develop a measurement method that allows for a separate analysis of the phase in which the vehicle is fueled with gasoline. This will allow the elimination of errors in the current normative method of calculating pollutant emissions from the exhaust system and fuel consumption of vehicles fueled with gaseous fuels.

The article presents the definition of bioindustry, in particular biorefinery. The technology for obtaining synthetic fuel EtG (Ethanol to Gasoline) in a plant using bioethanol from food waste was presented. The physicochemical properties of EtG fuel were presented. EtG fuel stands out due to its limited content of benzene and sulfur and a low content of mechanical impurities and heavy metals. EtG fuel can be considered a replacement fuel for motor gasoline. The results of exhaust emissions tests from vehicles with spark-ignition engines in the WLTC test on a hot and cold engine were presented. It was found that EtG fuel is characterized by lower specific distance emissions of CO, NOx and CH4 and slightly higher specific distance emissions of NMHC when starting a cold engine compared to gasoline, while the specific distance emission of CO2 for both fuels were very similar.