Permanent magnet synchronous machines (PMSMs) are widely used in electric vehicles due to their high power density, high efficiency, etc. Core losses account for a significant component of the total loss in PMSMs. Therefore, it is necessary to carefully consider it when designing PMSMs according to actual scientific research project applications. This paper extracts the characteristic operating points of the PMSMs under different operating conditions at different speeds. Then a harmonic analysis of air-gap flux density, phase current, core loss was completed, and detailed comparative analysis was performed. A novel method for comprehensively analyzing the stator core loss of PMSMs for vehicles is proposed, which reveals the law of the core loss of the PMSM under Maximum-Torque-Per-Ampere (MTPA) and Space Vector Pulse Width Modulation (SVPWM). The method was verified by a prototype experiment where the actual core loss of PMSMs was measured to verify the correctness of the method. This research provides a reference for accurately predicting core loss during the forward design of PMSMs and completing core loss evaluation for existing PMSMs.

This paper proposes a computationally efficient approach for mapping permanent magnet (PM) power loss in permanent magnet synchronous machines (PMSMs). The PM loss mapping method here uses time-step finite element analysis (FEA) to determine the function parameters representing the loss variation with speed (frequency), amplitude modulation ratio, carrier ratio, and stator current and is suitable for rapid evaluation of machine performance over the entire torque–speed envelope. The PM loss can be accurately mapped across the full operational envelope, including the field-weakened mode. The loss mapping procedure takes into account the equivalent resistivity of axial segmentation of the PM array calculated by three-dimensional (3-D) FEA. The effect of temperature on the PM loss is also considered. The proposed methodology is validated on two surface-mounted PMSM designs. The results of the loss mapping procedure are consistent with those from direct 3-D finite element prediction and experimental results of PM power loss at each operating point of the machine.