Neuroendocrine secretory products and their interactions with epithelial prostate cells are currently under investigation in order to understand their significance in the pathogenesis, prognosis, and therapy of prostate carcinoma. These neuropeptides have the potential to disrupt the balance between cell death and cell growth in the tumor. Our research was based on the role of bombesin in modulating the mitochondrial membrane potential (Δψ_m) in cell death induced by etoposide on PC-3 cells. Cells were cultured and stained with 5,5′,6,6′-tetrachloro-1,1′,3,3′-tetraethylbenzimidazolylcarbocyanine iodide (JC-1). At low membrane potentials, JC-1 produces a green fluorescence, and at high membrane potentials, it forms “J aggregates” with red fluorescence. Cells were examined in a confocal microscope. For quantitative analyses, regions of interest were selected. The size, number of pixels, and ratios between fluorescence intensity in the red and green channels in each region of interest were calculated. The loss of Δψ_m in etoposide-treated PC-3 cells was prevented by bombesin. The quantitative analysis of JC-1–stained cells revealed a significant decrease in the red (high Δψ_m) to green (low Δψ_m) ratio in etoposide-treated cells when compared with control cells, which was restored in the presence of bombesin (P < 0.00001). The interaction between treatments and area (P = 0.0002) was highly significant, and confirms that PC-3 cells keep their apoptosis machinery, showing an apoptotic volume decrease in response to etoposide. The protection by bombesin occurs by inhibition of apoptosis and maintenance of mitochondrial integrity. New therapeutic protocols and trials need to be developed to test drugs acting through the neutralization of antiapoptotic intracellular pathways mediated by neuroendocrine hormones. [Mol Cancer Ther 2007;6(4):1292–9]

This study introduces a new synthesis route for obtaining homogeneous chitosan (CS)-silica hybrid aerogels with CS contents up to 10 wt%, using 3-glycidoxypropyl trimethoxysilane (GPTMS) as coupling agent, for tissue engineering applications. Aerogels were obtained using the sol-gel process followed by CO₂ supercritical drying, resulting in samples with bulk densities ranging from 0.17 g/cm³ to 0.38 g/cm³. The textural analysis by N₂-physisorption revealed an interconnected mesopore network with decreasing specific surface areas (1230–700 m²/g) and pore sizes (11.1–8.7 nm) by increasing GPTMS content (2–4 molar ratio GPTMS:CS monomer). In addition, samples exhibited extremely fast swelling by spontaneous capillary imbibition in PBS solution, presenting swelling capacities from 1.75 to 3.75. The formation of a covalent crosslinked hybrid structure was suggested by FTIR and confirmed by an increase of four hundred fold or more in the compressive strength up to 96 MPa. Instead, samples synthesized without GPTMS fractured at only 0.10–0.26 MPa, revealing a week structure consisted in interpenetrated polymer networks. The aerogels presented bioactivity in simulated body fluid (SBF), as confirmed by the in vitro formation of hydroxyapatite (HAp) layer with crystal size of approximately 2 µm size in diameter. In vitro studies revealed also non cytotoxic effect on HOB^® osteoblasts and also a mechanosensitive response. Additionally, control cells grown on glass developed scarce or no stress fibers, while cells grown on hybrid samples showed a significant (p < 0.05) increase in well-developed stress fibers and mature focal adhesion complexes.

Silica (SiO₂)/chitosan (CS) composite aerogels are bioactive when they are submerged in simulated body fluid (SBF), causing the formation of bone-like hydroxyapatite (HAp) layer. Silica-based hybrid aerogels improve the elastic behavior, and the combined CS modifies the network entanglement as a crosslinking biopolymer. Tetraethoxysilane (TEOS)/CS is used as network precursors by employing a sol-gel method assisted with high power ultrasound (600 W). Upon gelation and aging, gels are dried in supercritical CO₂ to obtain monoliths. Thermograms provide information about the condensation of the remaining hydroxyl groups (400–700 °C). This step permits the evaluation of the hydroxyl group’s content of 2 to 5 OH nm⁻². The formed Si-OH groups act as the inductor of apatite crystal nucleation in SBF. The N₂ physisorption isotherms show a hysteresis loop of type H3, characteristic to good interconnected porosity, which facilitates both the bioactivity and the adhesion of osteoblasts cells. After two weeks of immersion in SBF, a layer of HAp microcrystals develops on the surface with a stoichiometric Ca/P molar ratio of 1.67 with spherulite morphology and uniform sizes of 6 μm. This fact asserts the bioactive behavior of these hybrid aerogels. Osteoblasts are cultured on the selected samples and immunolabeled for cytoskeletal and focal adhesion expression related to scaffold nanostructure and composition. The initial osteoconductive response observes points to a great potential of tissue engineering for the designed composite aerogels.

Chitosan (CS) is a natural biopolymer that shows promise as a biomaterial for bone-tissue regeneration. However, because of their limited ability to induce cell differentiation and high degradation rate, among other drawbacks associated with its use, the creation of CS-based biomaterials remains a problem in bone tissue engineering research. Here we aimed to reduce these disadvantages while retaining the benefits of potential CS biomaterial by combining it with silica to provide sufficient additional structural support for bone regeneration. In this work, CS-silica xerogel and aerogel hybrids with 8 wt.% CS content, designated SCS8X and SCS8A, respectively, were prepared by sol-gel method, either by direct solvent evaporation at the atmospheric pressure or by supercritical drying in CO₂, respectively. As reported in previous studies, it was confirmed that both types of mesoporous materials exhibited large surface areas (821 m²g⁻¹–858 m²g⁻¹) and outstanding bioactivity, as well as osteoconductive properties. In addition to silica and chitosan, the inclusion of 10 wt.% of tricalcium phosphate (TCP), designated SCS8T10X, was also considered, which stimulates a fast bioactive response of the xerogel surface. The results here obtained also demonstrate that xerogels induced earlier cell differentiation than the aerogels with identical composition. In conclusion, our study shows that the sol-gel synthesis of CS-silica xerogels and aerogels enhances not only their bioactive response, but also osteoconduction and cell differentiation properties. Therefore, these new biomaterials should provide adequate secretion of the osteoid for a fast bone regeneration.