Vadim Platonov

Dr. Vadim Platonov

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 November 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
NVNataliya Vorobyeva
Nataliya Vorobyeva
Marina RumyantsevaMarina Rumyantseva
Marina Rumyantseva
VPVadim Platonov
Vadim Platonov
DFDarya Filatova
Darya Filatova
ACArtem Chizhov
Artem Chizhov
Alexander M. GaskovAlexander M. Gaskov
Alexander M. Gaskov
Gallium(III) oxide is a promising functional wide-gap semiconductor for high temperature gas sensors of the resistive type. Doping of Ga2O3 with tin improves material conductivity and leads to the complicated influence on phase content, microstructure, adsorption sites, donor centers and, as a result, gas sensor properties. In this work, Ga2O3 and Ga2O3(Sn) samples with tin content of 0–13 at.% prepared by aqueous co-precipitation method were investigated by X-ray diffraction, nitrogen adsorption isotherms, X-ray photoelectron spectroscopy, infrared spectroscopy and probe molecule techniques. The introduction of tin leads to a decrease in the average crystallite size, increase in the temperature of β-Ga2O3 formation. The sensor responses of all Ga2O3(Sn) samples to CO and NH3 have non-monotonous character depending on Sn content due to the following factors: the formation of donor centers and the change of free electron concentration, increase in reactive chemisorbed oxygen ions concentration, formation of metastable Ga2O3 phases and segregation of SnO2 on the surface of Ga2O3(Sn) grains.

6 April 2023 in Chemosensors
Verified
Journal Article
Open access
PDF file
VPVadim Platonov
Vadim Platonov
NMNikolay Malinin
Nikolay Malinin
RVRoman B. Vasiliev
Roman B. Vasiliev
Marina RumyantsevaMarina Rumyantseva
Marina Rumyantseva
Nanocomposites, including nanoparticles of semiconductor metal oxide (MO) and reduced graphene oxide (rGO), are of exceptional interest for light-activated gas sensors functioning without thermal heating. In this paper, we discuss the sensor properties of electrospun ZnO nanofibers and ZnO/rGO composites. The materials were characterized by transmission and scanning electron microscopy (TEM, SEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and IR spectroscopy (FTIR). The sensor characteristics were studied when detecting reducing gases CO, H2, and NH3 and oxidizing gases NO and NO2 at 25–150 °C in dark conditions and under UV illumination. ZnO nanofibers and ZnO/rGO composites have no sensitivity when detecting CO, NH3, and H2 either in dark conditions or under UV illumination. At T = 25 °C, UV illumination is a necessary condition for the appearance of a sensor response when detecting both NO and NO2. The increased sensitivity of ZnO/rGO composites when detecting nitrogen oxides at T = 25 °C is discussed in terms of the heterojunction formation. Observed at T = 150 °C, opposite trends in the UV illumination influence on the sensor response toward NO and NO2 are due to the participation of chemisorbed oxygen in the processes responsible for the sensor response formation when detecting NO.

20 December 2020 in Sensors
Verified
Journal Article
Open access
PDF file
VPVadim Platonov
Vadim Platonov
Marina RumyantsevaMarina Rumyantseva
Marina Rumyantseva
NKNikolay Khmelevsky
Nikolay Khmelevsky
Alexander M. GaskovAlexander M. Gaskov
Alexander M. Gaskov
Variable air humidity affects the characteristics of semiconductor metal oxides, which complicates the reliable and reproducible determination of CO content in ambient air by resistive gas sensors. In this work, we determined the sensor properties of electrospun ZnO and ZnO/Pd nanofibers in the detection of CO in dry and humid air, and investigated the sensing mechanism. The microstructure of the samples, palladium content, and oxidation state, type, and concentration of surface groups were characterized using complementary techniques: X-ray fluorescent spectroscopy, XRD, high-resolution transmission electron microscopy (HRTEM), high angle annular dark field scanning transmission electron microscopy (HAADF-STEM), energy-dispersive X-ray (EDX) mapping, XPS, and FTIR spectroscopy. The sensor properties of ZnO and ZnO/Pd nanofibers were studied at 100–450 °C in the concentration range of 5–15 ppm CO in dry (RH25 = 0%) and humid (RH25 = 60%) air. It was found that under humid conditions, ZnO completely loses its sensitivity to CO, while ZnO/Pd retains a high sensor response. On the basis of in situ diffuse reflectance IR Fourier transform spectroscopy (DRIFTS) results, it was concluded that high sensor response of ZnO/Pd nanofibers in dry and humid air was due to the electronic sensitization effect, which was not influenced by humidity change.

2 November 2021 in Sensors
Verified
Journal Article
Open access
PDF file
MAMatvey Andreev
Matvey Andreev
VPVadim Platonov
Vadim Platonov
DFDarya Filatova
Darya Filatova
EGElena Galitskaya
Elena Galitskaya
SPSergey Polomoshnov
Sergey Polomoshnov
Marina RumyantsevaMarina Rumyantseva
Marina Rumyantseva
Continuous monitoring of greenhouse gases with high spatio-temporal resolution has lately become an urgent task because of tightening environmental restrictions. It may be addressed with an economically efficient solution, based on semiconductor metal oxide gas sensors. In the present work, CO2 detection in the relevant concentration range and ambient conditions was successfully effectuated by fine-particulate La2O3-based materials. Flame spray pyrolysis technique was used for the synthesis of sensitive materials, which were studied with X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), diffuse reflectance infrared Fourier transform spectroscopy (DRIFTs) and low temperature nitrogen adsorption coupled with Brunauer–Emmett–Teller (BET) effective surface area calculation methodology. The obtained materials represent a composite of lanthanum oxide, hydroxide and carbonate phases. The positive correlation has been established between the carbonate content in the as prepared materials and their sensor response towards CO2. Small dimensional planar MEMS micro-hotplates with low energy consumption were used for gas sensor fabrication through inkjet printing. The sensors showed highly selective CO2 detection in the range of 200–6667 ppm in humid air compared with pollutant gases (H2 50 ppm, CH4 100 ppm, NO2 1 ppm, NO 1 ppm, NH3 20 ppm, H2S 1 ppm, SO2 1 ppm), typical for the atmospheric air of urbanized and industrial area.

25 August 2022 in Polymers
Verified
Journal Article
Open access
PDF file
VPVadim Platonov
Vadim Platonov
ANAbulkosim Nasriddinov
Abulkosim Nasriddinov
Marina RumyantsevaMarina Rumyantseva
Marina Rumyantseva
The development of safety sensors is an urgent necessity for the successful use of hydrogen in real conditions, which may differ, in particular, by the oxygen content in the surrounding atmosphere. Palladium-modified zinc oxide shows the high sensitivity when detecting hydrogen in air; however, studies of the sensor properties and the operation mechanism of the ZnO/Pd sensor when reducing gases are detected in an oxygen deficient or inert atmosphere have not been effectuated. In this work, we synthesized the ZnO and ZnO/Pd nanofibers by electrospinning and for the first time determined their sensor properties in the detection of CO, NH3 and H2 in different oxygen backgrounds. The microstructure and composition of nanofibers were characterized by electron microscopy, X-ray diffraction, X-ray fluorescent spectroscopy, and X-ray photoelectron spectroscopy. The interaction with the gas phase was investigated in situ by diffuse reflectance IR Fourier transform spectroscopy (DRIFTS). The sensor properties of ZnO and ZnO/Pd nanofibers were studied at 100–450 °C towards CO, NH3 and H2 in the N2/O2 gas mixtures containing 0.0005–20% O2. When detecting CO, a decrease in the oxygen concentration from 20 to 0.0005% in the gas phase does not lead to a significant change in the sensor response. At the same time, when detecting NH3 and especially H2, a decrease in oxygen concentration down to 0.0005% results in the dramatic increase in the sensor response of ZnO/Pd nanofibers. This result is discussed in terms of palladium hydride formation, modulation of the potential barrier at the ZnO/Pd interface, as well as changes in the concentration of donor defects and charge carriers in the ZnO matrix. Synthesized electrospun ZnO/Pd nanofibers are extremely promising materials for sensors for detecting hydrogen in an oxygen free atmosphere.

11 August 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
ANAbulkosim Nasriddinov
Abulkosim Nasriddinov
VPVadim Platonov
Vadim Platonov
AGAlexey Garshev
Alexey Garshev
Marina RumyantsevaMarina Rumyantseva
Marina Rumyantseva
In this work we analyze the effectiveness of decoration of nanocrystalline SnO2/TiO2 composites with gold nanoparticles (Au NPs) and platinum nanoparticles (Pt NPs) in enhancing gas sensor properties in low-temperature HCHO detection. Nanocrystalline SnO2/TiO2 composites were synthesized by a chemical precipitation method with following modification with Pt and Au NPs by the impregnation method. The nanocomposites were characterized by TEM, XRD, Raman and FTIR spectroscopy, DRIFTS, XPS, TPR-H2 methods. In HCHO detection, the modification of SnO2 with TiO2 leads to a shift in the optimal temperature from 150 to 100 °C. Further modification of SnO2/TiO2 nanocomposites with Au NPs increases the sensor signal at T = 100 °C, while modification with Pt NPs gives rise to the appearance of sensor responses at T = 25 °C and 50 °C. At 200 °C nanocomposites exhibited high selectivity toward formaldehyde within the sub-ppm concentration range among different VOCs. The influence of Pt and Au NPs on surface reactivity of SnO2/TiO2 composite and enhancement of the sensor response toward HCHO was studied by DRIFT spectroscopy and explained by the chemical and electronic sensitization mechanisms.